Operation Instruction; Important - GreenWorks CS-80-XR-T Manual Del Propietário

OPERATION INSTRUCTION

ADDING BAR AND CHAIN LUBRICANT (See Figure 5)
Use Bar and Chain Lubricant. It is designed for chains and chain oilers, and is formulated to
perform over a wide temperature range with no dilution required.
NOTE: Pole saw comes from the factory with no bar and chain oil added. Level should also be checked after
every 30 minutes of use and refilled as needed.
• Remove oil cap.
• Carefully pour the bar and chain oil into the tank.
• Wipe off excess oil.
• Check and fill the oil tank when there is no oil in the oil tank.
• Repeat as needed.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or chain.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil
tank after each use then run for one minute. When storing the unit for a long period of time (three
months or longer) be sure the chain is lightly lubricated; this will prevent rust on the chain and bar
sprocket.
I M P O R T A N T
To preserve natural resources, please recycle or dispose of oil properly. Consult your local waste
authority for information regarding available recycling and/disposal options.
Fig.5
13