Tabla de contenido
y
x
13
v
w
a
RELEASING THE ISOFIX CONNECTORS
Carry out the installation steps in reverse order.
• Release the iSofix connectors (w) on both sides, by pressing and
pulling back the red release buttons (y).
• Pull the seat out of the iSofix guides (u).
• Turn the iSofix connectors (w) 180°.
• activate the handle (v) on the underside of the child seat and push the
connectors in until they reach the end position.
NOTE! ReTRaCTinG THe ConneCToRS noT only PRoTeCTS THe CaR
SeaT, BUT alSo PRoTeCTS THe iSofix ConneCT SySTem fRom DiRT
anD DamaGe.
PLACING THE CHILD SEAT IN THE CAR
• Place the child seat on the appropriate seat in the car.
• To install the seat in an upright position for the child it is essential to take care
that the backrest (a) of the child seat lies flush against backrest of the car
seat. To achieve this, push the seat toward the car seat backrest.
• By using the iSofix anchorage points (i) in the car, you can adjust
this distance with the handle (v) on the underside of the child seat.
• if the headrests of the car seats get in the way, pull these completely
out, turn them round, or detach them completely (exception see
section „THe BeST PoSiTion in THe CaR"). The backrest (a)
adjusts itself in one movement to almost every position of the car
seat.
!
Warning! The CYBEX JUNO-fix backrest must lie flush with the back
of the car seat. in order to guarantee maximum protection for the child,
the seat must be in a normal, upright position. (exception see section
„SiTTinG anD ReClininG PoSiTion")
NOTE! Some CaR SeaT CoVeRS maDe fRom DeliCaTe maTeRialS (e.G.
VeloUR, leaTHeR eTC.) may Be maRkeD By THe USe of CHilD SeaTS.
THiS Can Be aVoiDeD By PlaCinG a BlankeT oR a Towel BeneaTH
THe CHilD SeaT
Tabla de contenido
