Gree GWH09ACC-K6DNA1A/I Manual De Usuario página 14

Introduction for buttons on remote controller
to adjust fan speed. Press"
● When selecting heating mode, the air conditioner operates under heat mode.
Heat indicator "
models). Press "▲" or "
to adjust fan speed. Press "
only unit won't receive heating mode signal. If setting heat mode with remote
controller, press ON/OFF button can't start up the unit).
Note:
● For preventing cold air, after starting up heating mode, indoor unit will delay 1~5
minutes to blow air (actual delay time is d epend on indoor ambient temperature).
● Set temperature range from remote controller: 16~30 ℃ (61-86°F);
Fan speed: auto, low speed, low-medium speed,medium speed, medium-high
speed,high speed.
● Under auto mode, temperature can be displayed;Under auto mode,
set temperature can be adjusted.
3
FAN button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, ,
Low speed
Note:
● It's Low fan speed under Dry mode
●
X-FAN function Hold fan speed button for 2s in COOL or DRY mode, the icon "
displayed and the indoor fan will continue operation for a few minutes in order to dry
the indoor unit even though you have turned off the unit. After energization, X-FAN
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor unit will be blowed
after the unit is stopped to avoid mould.
Having set X-FAN function on: After turning off the unit by pressing ON/OFF
●
button indoor fan will continue running for a few minutes. at low speed. In this
period, Hold fan speed button for 2s to stop indoor fan directly.
● Having set X-FAN function off: After turning off the unit by pressing ON/OFF
button, the complete unit will be off directly.
4
TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode. "
to exit turbo function and "
" / "
" on indoor unit is ON (This indicator is not available for some
" button to adjust set temperature. Press "FAN" button
" / "
, then back to Auto.
to
Auto
Medium-High speed
" icon is displayed on remote controller. Press this button again
" icon will disappear.
" button to adjust fan blowing angle.
" button to djust fan blowing angle. (Cooling
Low-Medium speed
10
Medium speed
High speed
,
" is