Lelit William - PL71 Manual Del Usuario página 11

D
Check the functioning
Note.
Thanks to the pre-set parameters, the grinder is immediately ready to grind
your coffee.
D.1 Position the filterholder, with the correct filter inserted, on the fork (8) to
"hook" it with the pin (11).
Note.
In the case you can't insert your filterholder on the fork (8), you can change
the position of the upper filterholder pin (11), loosening it with a screwdriver to lift or
lower it. Once you found the optimal position, screw the pin back (11) to grant a secure
support for your filterholder.
D.2 To grind 1 dose, press once the grinding switch (7) (PUSH).
D.3 To grind 2 doses, press twice the grinding switch (7) (PUSH). The 2 presses
have to be within 2 seconds.
E
Grind the coffee
Note.
The grinder has been equipped with 50 mm flat mills, that grant a uniform
and professional grinding.
E.1 Check that the hopper is filled with beans and that it has the cover (1).
E.2 Turn the grinder on by pressing the on/off switch (5). The led light (6) will
go on confirming this.
E.3 Position the filterholder, with the correct filter inserted, on the fork (8) to
"hook" it with the pin (11).
E.4 To grind 1 dose, press once the grinding switch (7) (PUSH). The grinder
grinds the dose according to the set time. Wait until the grinding is over. Re-
move the filterholder from the fork (8).
E.5 To grind 2 doses, press twice the grinding switch (7) (PUSH). The 2 presses
have to be within 2 seconds. The grinder grinds the dose according to the set
time. Wait until the grinding is over. Remove the filterholder from the fork (8).
E.6. To grind any quantity of coffee continuously, press the switch (4) and keep
it pressed. Remove the filterholder from the fork (8) once the desired quantity
has been ground.
E.7. Check the grinding and the quantity per dose.
Note.
Once the grinding has started, you can stop it before the set time, pressing the
switch (4).
Lelit Espresso - English
EN
11