How To Assemble Your Ceiling Fan - Fanimation The Multimax FP8008CH1 Manual Del Usaurio

1. Loosen the three screws in the upper housing
then remove it. Retain the screws and upper
housing for installation in Step 6 (Figure 1).
2. Remove the hanger ball portion from the
downrod/hangerball assembly by loosening the set
screw in the hanger ball until the ball falls freely
down the downrod. Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 7
(Figure 2).
3. Loosen the two set screws in the downrod support.
Route black, blue and white lead wires through the
downrod (Figure 3).
4. Position downrod support and align the clevis pin
holes in both parts. Install the clevis pin and secure
with the hairpin clip. Tighten the two set screws
and locking nuts in the downrod support (Figure 4).
Assemble the Blades:
5. Securely fasten the four blades with screws and
steel washers (Figure 5).
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.

How to Assemble Your Ceiling Fan

Upper Hosing
Hanger
Ball
Set Screw
Set Screw and
Locking Nuts (2)
DOWNROD
Downrod Support
1/4"-20x1/2"
Screws with
steel washers
HARDWARE USED:
1/4"-20 x 1/2"
SCREWS W/
Spring Washer
1/4 STEEL WASHER
6
Figure 1
PIN
Figure 2
Black, Blue and
White Leads
DOWNROD
Figure 3
Set Screw and
Locking Nuts (2)
Figure 4
Blade
Figure 5
x 8
x 8