Cleaning Process - cecotec HidroBoost 2400 Home&Car Manual De Instrucciones

ENGLISH
• 2-SPIN BRUSH
This accessory, included with this model, is installed onto the product's lance and is made
of hard bristles. It spins and emits high-pressure water, allowing thorough and comfortable
cleaning. It is designed to clean patios, gardens and floors in general.

CLEANING PROCESS

1. Surface preparation
Clean the area of furniture and make sure all windows and doors are closed tight. Also, make
sure that all plants and trees near the cleaning area are protected by a drop cloth.
2. Initial high-pressure rinse
Spray the cleaning surface with water to clear off any dirt or grime that may have collected
on the surface. Before triggering the gun, adjust the pulverizing nozzle to a wide stream and
slowly adjust it to the desired stream. This will avoid applying too much concentrated spray to
the surface which could cause damage.
3. Soap application
The soap and water percentages should be, approximately: 5.4 % soap, 94.6 % water (1 to 19).
WARNING:
• Use only soaps designed for pressure washers.
• Test soap in an inconspicuous area before use.
1. Unscrew the soap bottle tap and fill the applicator with soap.
2. Screw the accessory tap back again.
3. Remove the lance from the gun.
4. Attach the soap bottle to the gun. (See Figure 3).
5. Apply soap so it thoroughly covers the cleaning surface. Apply from bottom to top to
prevent soap from sliding down and streaking.
6. Allow soap to remain on the surface for a few minutes. Meanwhile, use a brush to
lightly scrub heavily-soiled areas. Never allow soap to dry on the cleaning surface.
7. Remove the soap bottle from the gun and replace it with the lance, or remove the
accessory from the end of the lance.
8. Rinse soap from surface.
28 HIDROBOOST 2400 HOME&CAR