Putting Into Operation; Periodical Maintenance - IARP EFFE SMART SCREEN 42.2 Instrucciones De Empleo Y Manutención

PUTTING INTO
OPERATION
Check that the voltage on the identification
plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE
TO WHICH THE REFRIGERATOR
WILL HAVE TO BE CONNECTED IS TO BE
PROTECTED BY A VERY SENSITIVE DIFFERENTIAL
SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE
LINKED TO THE GENERAL EARTHING PLANT.
The manufacturer disclaims all responsability for any damage
to people or things due to incorrect observance of this rule.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords,
adapters or multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.

PERIODICAL MAINTENANCE

Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage.
If the power supply cable is damaged, don't use the equipment and don't try to repair it: to prevent any
risk, it must be replaced by the manufacturer, by a member of the after-sales service staff, or anyway by
a person having similar qualifications. In any case, none of the protective elements (the grill, the carter)
must be removed by non qualified staff. Absolutely avoid using the refrigerator without such protection.
Lights and video system are linked; if one of two systems is in failure, both systems don't work.
The replacement of led lamps must be carried out only by an Authorized Service Center.
The lamps have to be replaced by identical lamps only.
Let the LED lights cool down before replacement.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: wash with warm water and mild detergent, rinse well and dry
with soft cloth.
Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: only use products specifically designed for glass cleaning; It is not advisable to
use ordinary water which can leave a film of calcium on the surface of the glass.
SEASONAL USE
When the unit is not used for a long time, please take note of the following procedures:
-unplug the unit;
-clean and dry the tank well;
-leave the glass door open to avoid possible formation of bad odours;
-cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
-20-