Handling - Transport; Check Before Starting; Electrical Safety - Husqvarna FS 400 LV Manual De Explicaciones

04 - Water intake tap
05 - Service spanner
06 - Engine Moteur
07 - Disk casing Carter de disque
08 - Front guide Guide avant
09 - Lifting ring Anneau d'élingage
10 - Belt cover Carter de courroies
11 - Engine oil Sortie de vidange moteur
12 - Motor tensioning screw
13 - Tank
14 - Motor stop
15 - Circuit breaker
16 - Connector
17 - RCCB
18 - RCCB connector
19 - Wheel Lock
4 – HANDLING - TRANSPORT
Switch off the disk prior to moving the
machine on jobsite.
Remove the disk prior to hoisting,
loading, unloading and transporting
the machine on jobsite.
!"
Height of the handle-bar adjustable by pivoting.
!"
To position the floorsaw on the site, simply push
it. It will move easily on its four wheels without
starting the engine.
!"
For transporting by vehicle or by any kind of lifting
gear, there is a factory-fitted hoisting point on the
machine.
5 – CHECK BEFORE STARTING
Please read the instructions for use
prior to operating the machine for the
first time.
Moteur off.
The working area must be completely
cleared, well lit and all safety hazards
removed (no water or dangerous
objects in the vicinity).
The
mandatory.
Any persons not involved in the work
should leave the working area.
Use
maximum operating speed greater
than blade shaft speed
Petrol engine
maintenance manual) :
Take
conditions from health and safety
point of wiew.
!"
Check that the fuel tank is full.
!"
Check that the engine oil level is correct. As the
engine often operates at an angle, check the oil
level (with the engine horizontal) frequently to
ensure that it never falls below the second mark
on the dipstick.
!"
For starting up refer to the engine handbook.
Machine with electric motor. Check the following:
!"
The RCCB must be used correctly,including
testing it regularly. For tools supplied with an
integral RCCB in the cable or in the mains plug, if
the cable or plug has been damaged, repairs
must be carried out by the manufacturer, one of
his agents or by a qualified repair workshop to
avoid any risks resulting from errors.
!"
Motor power supply: reinforced electric cable with
4 (3P+E) or 5 (3P+N+E) conductors 2.5 mm2 for
lengths less than 100 m.
!"
Earthing of the machine (mandatory).
!"
Mains voltage (400 V).
!"
Direction of rotation of the motor : Direction of
rotation on the right hand side of the cover (if the
motor does not turn in the direction required
English - 3/6
The operator
protective
appropriate to the work he is
doing.
use
of
ear
only blades marked
machine (consult
into account
!"
ELECTRICAL SAFETY : Operate
this machine only on a supply
equipped with a 30 mA earthed
current-limiting
Otherwise, consult our catalogue for
appropriate models.
must wear
clothing
protection
is
with a
the engine
the working
circuitbreaker.