Self-Diagnose; Main Control Board - Airzone UNO PACK Manual De Instalación

Important: In Think thermostats, press
• Temperature range. Selects the highest temperature in heating mode (19-30 ˚C, 30˚C by default) and the lowest
temperature in cooling mode (18-26 ˚C, 18˚C by default). It is also possible to disable some of the modes.
• Use mode. The thermostats can be set in Basic or Advanced mode. They are set in Advanced mode by default. These
are the parameters you can control in basic mode: On/off, set-point temperature, fan speed and operation mode.
If you need to reset the thermostat to Advanced mode, access the advanced configuration menu and then activate
the advanced use mode.
•
0-10 V. Allows to control the minimum (1.5 V by default) and maximum (10 V by default) working fan voltage of the
controlled unit, in steps of 0.1 V. The minimum voltage corresponds with the desired lowest speed for the unit and the
maximum voltage corresponds with the highest speed. The medium speed corresponds with the mid point between
both of them.
• Offset. Allows you to correct ambient temperature that is measured in the various areas or in all of them, due to
deviations by sources of heat/cold nearby, with a correction factor between - 2,5ºC and 2,5ºC in steps of 0,5ºC. It is in
0ºC by default.
• Presence contact. If this contact is activated, the Sleep 90 function starts if after 5 minutes no presence has been
detected in the zone, displaying an "Active presence" notification on the thermostat's screensaver. To activate this
feature, configure it as Normally open or Normally closed.
• Window contact. If this contact is activated, the zone turns off after 60 seconds after the opening of a window,
displaying an "Active window" notification on the thermostat's screensaver. In order to activate this feature, configure
it as Normally open or Normally closed.
•
Reset thermostat. Allows you to reset the thermostat and returning it to the default values.

SELF-DIAGNOSE

MAIN CONTROL BOARD

UNO main control boards have integrated LEDs that detect unusual operations.
to confirm and to return to the previous menu/screen.
D2 Power supply
Data reception from thermostat
D3
Wireless data packets reception
Data transmission from thermostat
D4
Association channel: active
D14 Main control board activity
Led of relay state
Meaning
Solid
Blinking
Blinking
Blinking
Solid
Blinking
Switches
ES
EN
FR
IT
PT
DE
Red
Green
Red
Green
Green
21