Kit Contents
Item Qty
Description
1
1
Expediter Assembly
Support Cap w/ O-ring
Threaded Grommet Compressor
Grommet
Support Base w/ O-ring
2
1
Junction Box Lid
3
1
Junction Box Base w/ O-ring
4
1
Terminal Blocks w/ DIN Rail
(Refer to terminal specifications for maximum allowable wire size)
5
1
Junction Box Lid Cord
6
1
Nut
7
1
Banding Guide
8
1
Power Gland
9
1
Blind Plug
10
2
Conductor Wire Pins
11
1
Braid Wire Pin
12
1
Power Connection Boot
13
1
Ground Sleeve
14
1
RTV Tube
15
1
Banding
Tools Required
3 mm
8 mm
Certifications/Approvals
IP66 NEMA/Type 4X
Listed Heat Tracing Cable System 137M
Ordinary & Hazardous Locations
Class I, Division 2, Groups A, B, C & D
Class II, Division 2, Groups F & G, Class III
Class I, Zone 1, AEx e II T4-T6
Ex e II T4-T6
0539
II 2 G & D Ex e II T4-T6 DEMKO 06ATEX0622119
Warnings
Due to the risk of electrical shock, arcing and fire caused by
product damage or improper usage, installation or maintenance,
a ground-fault protection device is required.
Installation must comply with Thermon requirements (including
form PN 50207U for Ex systems) and be installed in accordance
with the regulations as per the norm EN IEC 60079-14 for
hazardous areas (where applicable), or any other applicable
national and local codes.
(per cable)
(per cable)
(per cable)
(per cable)
(per cable)
Terminator-LN-Tool
(order separately)
28 mm
29 mm
33 mm
-60°C ≤ Ta ≤ +55°C
1
4
6
7
PETK power termination components (per cable)
PETK-1:
for RSX, TSX, VSX
PETK-2:
for BSX, KSX, HTSX
PETK-3:
for HPT
10
12
11
B-type banding
- order separately
B-4:
for pipes up to 4"
B-10: for pipes up to 10"
B-21: for pipes up to 21"
Component approvals and performance ratings are based on the
use of Thermon specified parts only.
De-energize all power sources before opening enclosure.
Keep ends of heating cable and kit components dry before and
during installation.
Minimum bending radius of heating cable is 32 mm (except HPT
is 57 mm and FP is 19 mm).
2
3
5
8
- order separately
14
13
15
1
9
