1. Manuales
  2. Marcas
  3. Thermon Manuales
  4. Cables y Conectores
  5. PETK-1
  6. Instrucciones de instalación

Thermon PETK-1 Instrucciones De Instalación

Ocultar thumbs
1
2
3
4

Enlaces rápidos

Power and End Termination Kit
Installation Instructions
PETK-1
for use with KSR, RSX, TSX, VSX self-regulating heating cables
in conjunction with
Thermon JB-K-EX, TED, Terminator Z(P, L, T)-L kits in hazardous areas
and with JB-K-IND, TC in non hazardous areas
European Headquarters
Thermon Europe B.V.
Boezemweg 25
•
2641 KG Pijnacker
PO Box 205
•
2640 AE Pijnacker
•
The Netherlands
Phone: +31-(0)15-36 15 370
•
Facsimile: +31-(0)15-36 15 379
Website: www.thermon.com
Corporate Headquarters
Thermon Manufacturing Company
100 Thermon Drive
•
San Marcos, TX 78666
•
U.S.A.
Phone: +1-512-396-5801
•
Facsimile: +1-512-396-3627
For the Thermon office nearest you visit us at
www.thermon.com
For Power and End Termination (1 Heating Cable) Applications
THERMON...The Heat Tracing Specialists
loading

Manuales relacionados para Thermon PETK-1

Resumen de contenidos para Thermon PETK-1

  • Página 1 Installation Instructions PETK-1 for use with KSR, RSX, TSX, VSX self-regulating heating cables in conjunction with Thermon JB-K-EX, TED, Terminator Z(P, L, T)-L kits in hazardous areas and with JB-K-IND, TC in non hazardous areas European Headquarters Thermon Europe B.V.
  • Página 2 Installation must comply with Thermon requirements and be installed in accordance with the regulations as per the norm EN IEC 60079-14 for hazardous areas (where applicable), or any other applicable national and local codes.
  • Página 3 Crimp conductor wire pins on each conductor. Crimp braid TSX, VSX junto con Thermon JB-K-EX, TED, kits Terminator Z(P, L, T)-L en zonas clasificadas con riesgo de P2. Dégager localement la tresse et extraire le câble tel qu’indiqué. Effectuer une “queue de cochon”, explosión y con JB-K-IND, TC en zonas ordinarias.
  • Página 4 End Termination Instructions Power and End Termination Cable Take-off Cut and remove overjacket. Apply a liberal amount of RTV sealant to end cap and inside overcap. Slide overcap onto end of cable. Push back braid onto overjacket. Cut V-notch into end of cable. Apply a liberal amount of RTV sealant to cable and inside end cap.