D-Link NetDefend DFL-1660 Guia De Instalacion página 3

Name Color Status - Description
Light Off - Device is
Power Green
powered off.
Solid Green - Device is
powered on.
Light Off - Device is
System Green/
Orange powered off or is starting
up.
Solid Green - System is
normal operation.
Solid Orange - System
failure or license
lockdown.
TX/RX Status Green Light Off - No Link.
Solid Green - Link
present.
Blinking Green - Port is
sending or receiving data.
LINK Speed Green/ Light Off - Port is
Orange operating at 10Mbps.
Solid Green - Port is
operating at 100Mbps.
Solid Orange - Port is
operating at 1000Mbps.
Table 3. Device Status LED Descriptions
LCD Panel Keypad Controls During Boot-up
When you power on the DFL-1660, the LCD
panel will display following message: "Press
keypad to enter setup". Once you press any
key on the keypad, it will lead you to enter
the startup menu. If you don't press any keys
after five seconds, the device will automatically
continue the NetDefendOS boot-up procedure.
Confirm Button
Not Used
Back Button
Figure 3. Button Definitions (During Boot-up)
If you press any keypad buttons within five
seconds of powering the firewall on, the LCD
panel will display three options:
<Start Firewall>
If this option is selected, the system will
initialize, start the NetDefendOS software, and
load the saved configuration.
<Reset Firewall>
If this option is selected, the hardware will reset
to factory defaults. This option will carry out the
following steps:
- Remove console security so there is no
console password.
- Restore all NetDefendOS settings to their
default configuration
<Restore Config>
When you select this option, the system will
restore all NetDefendOS settings to their
default configuration. Other options, such as
console security, will not be affected.
Note: Once you select "Reset Firewall" or
"Reset Config" and confirm these options, all
saved settings will be permanently erased.
LCD Panel Keypad Controls After Boot-up
Once the DFL-1660 has completed its system
startup routine, the LCD panel will be ready
to display the device status information. You
can use the keypad to select a desired display
option. The following table lists the status infor-
mation that can be displayed on the firewall's
LCD panel.
Next Button
Next Button
Back Button
Figure 4. Button Definitions (After Boot-up)
D-Link NetDefend Firewall  3