Before Use - Hamilton Beach Commercial SmartServe Serie Manual De Operación

Sanitizing SmartServe™

Before Use

SmartServe™ must be sanitized before daily use.
1. Wash SmartServe™ following instructions in
"General Cleaning" on page 9.
Sanitize using 15 ml (1 tablespoon) of bleach
2.
per 3.8 liter (1 gallon) of clean, cool water
(60°F/16°C), mixed according to the instructions
on the bleach. (If using a sanitizing solution
other than bleach, test the concentration using
commercial test strips. Concentration levels
should be between 100 and 200 parts per
million of bleach to water.)
Turn ON (I) by pressing the power switch (3)
3.
under the control panel (2) on the right side.
Insert cup filled with sanitizing solution.
4.
Close door (5).
For MIC Only:
• Remove thumbscrews (6).
Blending or Mixing Instructions
Place cup in cup holder (8), close door (5), and
1.
press START button (2a).
2. Cup shield (14) lowers and SmartServe™
begins to blend drink.
If a different setting is desired, open control
3.
panel (2) cover if needed and press the choices
using the 1–3 and A–C buttons. Display will
show the buttons that are lit.
4. Press START. Display shows "BLENDING . . ."
NOTE: Text on screens may vary depending on
model number.
840225900 v12.indd 7
Run any preprogrammed cycle (using the 1–3
5.
and A–C buttons). DO NOT OPEN DOOR (5)!
For MIC Only:
• At end of cycle when cup shield (14) moves
upward, slide the door assembly (9) toward
you slightly to pause the cycle.
• Use sanitizing syringe (17) to inject 60 ml of
sanitizing solution into the sanitizing port (11).
Remove sanitizing syringe (17) and set aside.
• Wait 2 minutes or appropriate sanitizing time.
• Replace door assembly (9) and thumbscrews
(6).
Cycle will now finish and return cup shield (14)
to the highest position.
6. After appropriate sanitizer time, remove cup
and pour contents down the drain (10).
7. Allow the equipment to rinse.
For MIC Only:
• Press the RINSE button (2b).
NOTE: If this is done at end of day, turn OFF (O)
and remove door assembly (9) to allow parts to
dry fully.
When cycle ends, the cup shield raises back up
5.
and the display shows "BLEND COMPLETE –
PLEASE RINSE." DO NOT OPEN DOOR (5)
UNTIL THE SHIELD HAS RETURNED TO THE
HOME POSITION.
Remove cup. Close the door (5). The cup
6.
shield will lower into wash chamber (10).
Rinsing cycle runs for a predetermined time
period and shield raises. Display will show
"RINSE COMPLETE." DO NOT OPEN DOOR (5)
UNTIL THE SHIELD HAS RETURNED TO THE
HOME POSITION.
7
4/22/15 3:48 PM