Hamilton Beach Commercial SmartServe Serie Manual De Operación página 5

Installation
Unpacking SmartServe™
Excessive Weight Hazard.
w WARNING
Use two or more people to move and install equipment. Failure to do so can result in serious injury or
damage to the equipment.
1. Carefully lay carton on its
side. Remove tape from
one end and open flaps.
Lift carton back to upright
2.
position onto the opened
part of the carton. Lift
carton to remove.
Repeat Steps 1 and 2 for
3.
inner carton.
Remove black drain
4.
pipe (21) from top of
styrofoam and set aside
for installation.
Remove top and bottom
5.
styrofoam pieces and
additional cardboard
pieces.
Installing SmartServe™
Crush Hazard.
w WARNING
Follow instructions below for bolting to the countertop to avoid unit tipping over.
Carefully place
1.
SmartServe™ onto
countertop.
SmartServe™ must be
2.
bolted to countertop
using provided stability
brackets (22) attached
to the back of the
equipment. Follow
instructions below for
securing to countertop
with bolts, washers, and nuts.
If using stainless steel cap bolts:
Minimum – M5 (.8) or #10-32 stainless steel
cap bolts of appropriate length, appropriate flat
washers below bolt head and below countertop,
nuts
840225900 v12.indd 5
6. Remove cup holder (8)
from inside of cardboard
and carefully insert cup
holder (8) into wash
chamber (10), ensuring
that three hollow bosses
(on bottom of cup
holder (8)) rest on three
matching posts in wash
chamber (10).
Attach a standard 1/4"
3.
OD semi-rigid water line
for rinsing.
Insert drain connection
4.
using supplied black
drain pipe (21), or
standard 3/4" PVC pipe
and fittings. Standard
PVC glue should be used
to ensure there are no
leaks.
Recommended – M6 (1.0) or 1/4-20 stainless steel
cap bolts of appropriate length, appropriate flat
washers below bolt head and below countertop,
nuts
5
4/22/15 3:48 PM