Operation - Extel WEVPSF 659 Instrucciones De Uso E Instalación

To complete installation of the roadside panel, open the battery compartment on the electronic box , box and
insert four 1.5 V alkaline LR20 batteries. , Be sure to follow the polarity markings (fig. 7, p 8). Close the battery
compartment and put the electronic box cover back in place with the 6 cross-head screws (H), Take care not to
pinch or damage the seal. Do not obstruct the two ventilation slots (T) at the bottom of the electronic box (fig.
2, p 6).You can use a low voltage supply power source, coming from a type WETR 14602 transformer or from an
automatic gate opener (12 or 24 VDC/AC) (fig 9). It should be connected to the terminals and the electronic
cabinet. In the case of direct voltage (VDC) pay attention to the polarity +/-.
6

OPERATION

Warning : If you try your video door phone before installing it (short distance trial) respect a minimum of 3 m
distance between the monitor and the roadside panel (risk of saturation).
The monitor must be in standby mode, the indicator PWR/REC turned blue. (this mode is activated with
must be installed on a stable surface, with the antenna unfolded. When the Call button is pressed on the roadside
panel the monitor will ring for approximately 8 seconds.At the same time, a tone will sound on the roadside panel
to confirm that the call has been sent. You have approximately 30 seconds to answer the call. At this time, the
electronic box enters standby mode. If the electronic cabinet is powered by a 12 or 24 VDC/AC source, you can
force the communication with the roadside panel pressing the
the call is lost.
The conversation is established during a call pressing the
The system will time out after 60 seconds. To extend this time for an additional 60 seconds, press the Answer
buttons & . You can end the communication pressing
used with an electric strike plate (or electric lock) :
The electric strike plate can be opened only when communicating with a caller(all the time if the electronic
cabinet is powered by external AC/DC supply), To open it, press the
Caution :
One single opening control is possible per call under operation on battery.
N.B. : The strike plate or lock must be «one pulse type» in order for the door/gate to be opened.
Caution : An automatic gate opener may be operated via remote control If the electronic cabinet is powered
by external AC/DC supply. To open it, press the
Reminder :The reception of a call on the monitor is only possible if it is in standby mode and paired with the
roadside panel (see chapter Pairing).
Important : The handset has a free-field range of up to approximately 300 metres. This range may be considerably
reduced by certain environmental factors (nearby radio interference, etc.)
If you do not use the batterie but by 12/24 VAC/DC
source (automatic opener) to connect as indicated
opposite.
Caution : In the case of a continuous tension (VDC)
please respect a polarity +/-.
10GB
:
.
fig.9
CFI EXTEL WEVPSF 659 - 06/2010 - V1
key. If the electronic cabinet is battery-powered
. key
for 2 seconds.
.
LOCK
+
12/24 V AC/DC
-
) It