Temperature Monitoring; Power Failure Mode; Operating With External Festool Battery Pack [2A] + [2B]; Setup Options - Festool SYSLITE KAL II Manual De Instrucciones Original

6.4

Temperature monitoring

If the temperature of the light exceeds
the maximum or minimum permitted
operating temperature, the working light
switches to emergency power mode with
reduced luminosity and then switches off
after 2 minutes.
6.5

Power failure mode

The working light has a power failure
mode. It can assume the lighting of the
work area in the event of a sudden power
failure.

Hold down the ON/OFF switch [1-2]
and insert the mains charging adapter
or car charging adapter in the connec-
tor socket [1-4].
The working light goes out and the
charging indicator switches to flashing
orange (charging) or continuous orange
(charged). depending on the operating
state.
In the event of an interruption to the ex-
ternal voltage supply, the working light
automatically switches on.
Switching off the mode:

Press the ON/OFF switch [1-2] again.
Charging indicator switches to standard
mode, see
chapter 6.1
6.6 Operating with external Festool
battery pack [2A] + [2B]
The working light can operate with any
Festool battery pack from the BPC or
BPS series. When connected to the ex-
ternal Festool battery pack, the working
light only consumes power from this bat-
tery pack.
.

Only compatible Festool chargers
can charge the Festool battery
pack.
6.7

Setup options

Attachment handle [1-3]
The folding attachment handle allows
you to hang the working light from scaf-
folding or similar structures.

If you decide to operate the light
with an external Festool battery
pack, the attachment handle must
be detached beforehand [2A].
Setup angle
The working light can be positioned at
three different angles [3].
Tripod
A standard photographic tripod with UNC
1/4"-20 thread can be attached to the
threaded tripod socket [2-1].
Magnetic foot with spherical head (part
accessories) [4]
The magnetic foot can be screwed on to
the stand threaded bushing [2-1]. This
can be rotated in all directions by slack-
ening the clamping screw [4-1].
Secure the magnetic foot using one of
three options:
[4A] Secure with a clamp
[4B] Magnetic mounting at the
screwed-on adapter plate
[4C] Magnetic mounting at the adapter
plate screwed on to a stand thread
GB
KAL II
13