How To Check Using Control Solutions - IBP TD 3213 Instrucciones Para El Uso

10 checking the system

how to check using control solutions

1. Feed your test strip into the test strip opening with the contacts first, and
the device display facing you (see Fig. 7). You should ensure that the
test strip is firmly located in the device to achieve exact measured results.
The device switches itself on automatically. All digits in the display will
light up briefly. After this, the surrounding temperature, the symbol
and the code number are displayed. You should calibrate your device
(see Page 13) if the code number shown in the display is not the same
as the code number on the test strip container.
2. Shake the control solution well before using it. Unscrew the cap and
squeeze one drop out. Wipe the first drop away, and then squeeze
another one out. Put the drop onto your fingertip (Fig. 8).
Note: In order to make sure that the control solution is not contaminated by
contact with the test strip, do not apply the drop directly to the strip,
but first apply it to something clean or to your fingertip.
16
(Fig. 7)
(Fig. 8)