Operation; Inserting / Removing The Module - TDK relyon plasma piezobrush PZ3 Manual De Instruccion

7

Operation

7.1

Inserting / removing the module

The modules are provided with labels in different colors for easy identification. Please do
not remove these labels.
To insert a module, take it out of the packaging and hold it in the area of the nozzle outlet
without touching the piezo element (picture 1).
Please note that the contact board of the module must be on the same side as the
display of the device to allow insertion.
Carefully insert the module into the device as shown in the picture without using force
until the module locks into place.
When the device is switched on, the type of module detected is now shown in the display.
To remove a module, wait until it has cooled down. Depending on the type of module,
operation can lead to a significant increase in temperature.
Hold the device in one hand, press both release buttons simultaneously and keep them
pressed. With the other hand, hold the module in the area of the nozzle outlet without
touching the piezo element and carefully pull the module out of the device (picture 2).
Caution – hot surface!
The exchange modules can become hot during operation. Do not touch them until they
have cooled down and take care not to damage thermally sensitive surfaces when
working with the exchange modules.
Attention – Damage to device!
Do not reach into the interior of the unit if no module is inserted and do not insert any
objects into the opening of the unit other than the modules provided for this purpose.
Hold the modules only in the front area as described above and avoid touching the
contact board and the piezo element.
Insert and remove the modules carefully.
BA-PZ3_ML / F0354401
1 2
15