Clothing; Use - Texas Hobby 500 B Manual De Instrucciones

thinner, so it is easier to add to the gear. Avoid cutting off too much of the tip on the
pack. It is important that the tip is as pointed as possible.
Add grease until it comes out of the filler hole when the machine is horizontal.
Operate the clutch lever and pull the starter cord 3 times to distribute the grease
-
around the gear.
Then add more grease until the gear is full.
-
Fit and tighten the screw.
-
Fit the spark plug cover on the engine.
-
Figure 9
Check grease level and top up the gears every 5 operating hours.

Clothing

When using the machine, wear tight-fitting work clothes,
strong working gloves, hearing protectors and boots with
non-skid soles and toe caps are compulsory.

Use

Remove all foreign bodies from the area before use. Stone, glass, branches, etc. can
damage the tiller. Check that all bolts on the tiller are tightened.
Starting:
Set the throttle handle to choker/full throttle.
Follow the instructions in the user manual to start.
Stopping:
Set the throttle handle to minimum throttle.
Follow the instructions in the user manual for stopping.
The Hobby 500 cultivator is intended for use in vegetable gardens and flowerbeds. It can
also be fitted with various accessories for a variety of tasks.
Read the engine manual carefully, especially the part about starting and stopping.
When the gear lever on the right of the handle is pressed down, the rotor blades begin to
turn. To ensure optimum belt tension, is it important to press the lever all the way down
towards the handle. The belt transmits power from the engine to the transmission.
For best results, cultivate the soil 2-3 times in different directions.
Figure 14
If the tiller has a tendency to dig in, there are several things you can do. The right and left
blade set can be changed. This means that the tiller will use the back of the blade to till, so
it will not be so easy to dig in. In addition, side guards can be fitted. This also helps
prevent the tiller from digging in.
The depth skid must always be placed in the top notch if this is the case. See also the
section on adjusting the depth skid.
13