Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation Instructions – LSRWM6B / LSSQRWM6B Commercial LED Rough-In
INSTALLATION
Wall Mount Section
N
otee:
LED Trim assembly to be installed only after cyclinder
is installed.
1.
Install wall mounting plate to splice box using splice
box hardware (provided by others) and tighten to
17 IN/LBS torque when using 8-32 screw (Figure 1).
2.
Wire unit per appropriate Wiring Diagram (refer to
electrical section).
3.
Attach rear wall mount tether to splice box mounting
screw.
4.
Mount cylinder housing assembly to wall by tightening
screws on top and bottom of arm base to 17 IN/LBS
torque to engage mounting plate.
5.
Installer must apply silicone compound around entire
perimeter of the mounting arm where it mates to the
mounting surface.
Trim
1.
Remove LED engine from protective packaging.
2.
Remove trim assembly from protective packaging,
discard plastic trim ring, and rotate side clips (3)
outwards (Figure 3).
3.
Insert LED engine on to trim assembly. Align post on
LED engine with slot on trim assembly (Figure 4).
Figure 1.
Luminaire
Quick
Disconnect
LED Engine
Trim Assembly
Figure 2.
2
Torsion
Springs
Installation Instructions – LSRWM6B / LSSQRWM6B Commercial LED Rough-In
IB520018EN www.eaton.com
Figure 3.
Figure 4.
Figure 5.
Figure 6.
Side Clips
Tabla de contenido
