Configuration - D-Link DAP-3310 Guia De Instalacion

STEP 3: Connect Grounding Wire
A grounding wire is recommended to
4
protect your device from lightning strikes
and the buildup of static electricity.
A grounding wire is not included in the package.
4
It is suggested that you use 16 to 18 AWG
grounding wire.
STEP 4: Connect the AP to Your Network
AP
LAN (PoE)
A
P+DATA OUT
POWER IN
C
Router or Switch Computer
This product uses a proprietary PoE design and
5
can only be used with the included PoE injector.
A. Connect the Ethernet cable that is
connected to the AP from STEP 1 to the
P+DATA OUT port on the PoE Injector.
B. Connect an Ethernet cable from a router,
switch, or PC to the DATA IN port on the
PoE Injector.
C. Attach the power adapter to the connector
labeled POWER IN on the PoE Injector,
and plug it into an electrical outlet.
5
PoE Injector
5
DATA IN
B

Configuration

If you are configuring the AP locally,
connect a PC to the PoE Injector DATA IN
port using an Ethernet cable.
A. Assign a static IP address to your PC
that is in the same network segment as
the device. As the default IP address
of this unit is 192.168.0.50, you may
choose any address from 192.168.0.1 to
192.168.0.254, except 192.168.0.50.
B. Open a web browser and go to
http://192.168.0.50. Enter admin as
your username and leave the password
blank to log in to the web UI. Now you
can configure the AP through the web UI.
PoE Passthrough
LAN 2
Camera
6
The LAN 2 port can be connected to D-Link
6
cameras that require up to 7 watts, such as the
DCS-3716, DCS-6113, and DCS-7110. It can
also be connected to a router or a switch.
A. Power on the AP through the PoE kit (as
in STEP 4) and connect the camera to
the LAN 2 port.
B. Log in to the web UI and enable PoE
Passthrough in Maintenance to power on
the camera.
6
D-Link DAP-3310/DAP-3410 Quick Install Guide  3
AP
LAN (PoE)
6 5
PoE Injector
Router or Switch Computer
5