GYS Multi PEARL 200-2 Manual De Uso página 23

Translation of the original instructions
PROCEDURE FOR CHANGING REELS AND TORCH ASSEMBLY (FIG IV)
• Remove the nozzle from the torch (fig E) and the contact tip (fig D).
• Open the machine's side door.
• Place the reel on the driving pin (fig A) of the reel support. For a 200mm wire reel tighten the reel to the maximum. The adaptor
(1) is only to be used for a 200mm reel.
• Adjust the reel brake (2) to avoid the reel inertia tangling the wire when welding stops. In general, do not over-tighten! Then screw
in the reel support (3).
• Fit the roller(s) suitable for your application. The rollers supplied are double grooved rollers (0.6/0.8). The indication on the visible
side of the roller is the diameter in use. For a 0.8 wire, use the 0.8 groove. For Aluminium or cored wire welding use the appropriate
rollers (fig B)
To adjust the roller tension (fig C), process is as follows: loosen the tensioner to the maximum (4), start the motor by pressing the
torch trigger, tighten the tensioner whilst pressing the trigger. Bend the wire where it comes out of the nozzle and hold it in place to
stop its progress. The pressure adjustment is ideal when the guide roller slides over the wire even when it is blocked at the end of
the torch.
NB: for aluminium wire set the tension to the minimum not to pinch the wire.
• Adjust the wire so 5cm protrudes from the torch then fit the contact tip (correct tip for the wire) (fig D) and the nozzle (fig E).
GAS CONNECTION
The device is designed with a quick release gas connection. Use the adaptor supplied with the machine.
FE
Type of wire
MAG
Process
Ar+CO²
Gas
0.6 - 0.8 0.6 - 0.8
Ø available
- 1.0
Welding
All
position
MMA
• Selecting MMA mode
• Welding current adjustment
• Arc Force adjustment
• Hot Start adjustment
MULTIPEARL 200.2 / 200.4 XL / 201.4
FE ALG 5 SS
MAG MIG MAG
CO² Ar
Ar+CO² 2%
0.8 - 1.0 0.8 - 1.0
- 1.0
All All All
Keep button 2 pressed and at the same
time turn the upper knob to select MMA
mode.
Turn the upper knob to select the wel-
ding current.
Turn the lower knob to adjust the Arc
Force.
Adjustable from 0 to 100%
Keep pressing button 3 and at the same
time turn the upper knob to adjust the
Hot Start.
Adjustable from 0 to 100%
FC CuSi 3 CuSi 8
MAG MIG MIG
Ar Ar
0.9 -1.2 0.8 0.8 - 1.0
All Flat Flat
CuAL ALSi 5
MIG MIG
Ar Ar
0.8 1.0
Flat All
+
+
EN
ALSi 12
MIG
Ar
1.0
All
23