Cleaning & Maintenance - Berthoud Vermorel 3000 Electric Manual De Instrucciones

4 - USE
1. Preparing the solution to be sprayed:
a. Product in powder form (soluble or
wettable)
Prepare the solution in a bucket before
transferring it to the tank through the filler
opening, using
"ELECTRIC".
b. Liquid-based product
Put 1 to 2 litres of water into the tank, pour
the dose of liquid product and then top up
with water to the desired quantity, using
the gauge marked "ELECTRIC".
2. Screw the filler plug by hand on the tank.
3. Fully unfold the telescopic
lance. Purge the air by pointing your
lance up and by pressing on the
trigger for a few seconds; this ensures
the proper operation of the anti-drip
system and the pressure regulator. (Fig. 3).
4. Flip the switch to ON position (Fig. 6)
5. Select the
depending on your nozzle and your use
(Section 7)
6. Press on the trigger for a few seconds. Your
machine will calibrate the pump depending
on the nozzle and the selected pressure.
7. Then adjust the telescopic lance to the
desired length.
8. Press on the trigger to spray. When you
release the trigger, the motor stops.
9. The battery charge level is indicated by 4
LEDs (Fig. 6). Each LED represents 25% of
charge.
NOTE:
If your motor stops and the red indicator on the
unit flashes during application, it means that you
must recharge your battery.
5 - CLEANING / MAINTENANCE
After every use:
1. Collect the EXCESS mixture that may
remain in the tank
2. Rinse the tank.
3. Clean the tank's filler filter.
4. Clean the suction filter located on the base
of the tank after fully draining the rinsing
water. You can remove this filter by pulling it
the gauge marked
recommended pressure
.
ENGLISH
up. Never remove it by unscrewing. (see
Section 11)
5. Rinse the filter by running water through the
inside (Rinse under a tap).
6. Refit it by simply snapping it on, without
screwing.
7. Rinse the circuit by spraying 2 to 3 litres of
clean water.
8. Charge the sprayer before storing it.
NOTE: The sprayer must always be stored
without water or treatment product at a
temperature higher than 5° C and must be
checked every year.
During transport, the sprayer must be secured
tightly to avoid any risk of fall, collision or injury.
6 - USABLE NOZZLES
VERMOREL 3000 "ELECTRIC" is characterised
by an operation at CONSTANT PRESSURE,
regardless of the battery charge level. The
FLOW RATE and PRESSURE values are
selected EXCLUSIVELY using the Selector
button (Fig. 6).
Fungicide
HP
Insecticide
Non-
selective
herbicide
Selective
herbicide
Recommended
Impossible
Every time the nozzle is changed,
you must switch your machine off
and then on again so that it
recalibrates itself.
BOOM
LP LP
LP