Connecting The Power Supply Of The Vehicle Terminal; Connection To Mains (Ac Voltage 110 V, 60 Hz); Connection To A Battery (Dc Voltage) - ACD MFT10 Manual Del Usuario

4.2 Connecting the power supply of the Vehicle Terminal

Depending of the usage of the MFT in forklifts or rider-controlled trucks with batteries or in conjunction with a
table power supply on mains there are different connection schemes.

4.2.1 Connection to mains (AC voltage 110 V, 60 Hz)

Connection scheme (not true to scale)
MFT rear side

4.2.2 Connection to a battery (DC voltage)

Connection scheme (not true to scale)
MFT rear side
15pol.
Sub.-D.
3 wire ACD power supply cable

Please connect the MFT as near as possible to the battery in respect of
the length of the power supply cable, with no loops to the cabling of the
machine.
NOTE
MFT10_Brief Overview_Resumen_breve_FCC_V1.00_en_es
15pole
Sub.-D.
wire identification„
IGN" ignition signal
ACD table power supply
wire identi-
fication „1"
minus (-)
-
+
wire identi-
fication „2"
plus (+)
IGN
switch/button
ignition
mains side,
voltage
depends on
the country .
mains plug
battery,
12 V DC, 24 V DC
or 48 V DC
-
negative pole
+
positive pole
fuse 10A
slow-blow
8 / 40