ACD MFT10 Manual Del Usuario página 6

Cables have to be fitted and mounted in a way that there is no
possibility of hooking of a barrier or that persons can be captured
by the cable when the vehicle moves.
This affects the cable of the power supply as well as the cables of
ATTENTION
the interfaces (COM, USB, Audio).
The device is equipped with the following radio systems: WLAN
and BT
Frequency bands:
ATTENTION
Max. transmission power in frequency bands:
Please observe the following national regulatory restrictions for
wireless devices.
WLAN restrictions:
ATTENTION
Voltage may occur on the inside of the device, which may lead to
severe or even fatal injuries when touching live parts or handling
the device in an improper manner. It may also lead to severe
material damage.
The device may only be opened by trained specialists, and only
after consulting with ACD.
ATTENTION
The device may only be attached in the position intended by the
holding bracket.
To ensure a seal tightness of IP65, the cover on the right side of
the device must be used and also the black cover of the cable
entrance area. Therefore the appropriate sleeves for the suitable

cable cross-section must be used (determine the cable cross
section with a caliper).
NOTE
Feed-throughs not used with a cable must be terminated with a
dummy plug (same size). The black cover itself must be screwed
with the related rubber seal ring.
MFT10_Brief Overview_Resumen_breve_FCC_V1.00_en_es

WLAN
2.412 GHz – 2.472 GHz
5.15 GHz – 5.35 GHz
5.47 GHz – 5.725 GHz

Bluetooth
2.402 GHz – 2.480 GHz

WLAN 2.4 GHz band max. 100 mW

WLAN 5 GHz band max. 200 mW

Bluetooth max. 100 mW
 In the EU, the WLAN 5 GHz band (5.15 GHz – 5.35 GHz) may only
be used indoors.

In France, WLAN may not be used at a value greater than 10 mW
outdoors (channels 8 – 13) when in the 2.454 GHz – 2.4835 GHz
band.
6 / 40