Handling Of The Device; Switching The Device On And Off; By Keys; By Ignition - ACD MFT10 Manual Del Usuario

4 Handling of the Device

4.1 Switching the Device On and Off

4.1.1 By keys

When in standard mode, the device is switched on via the OK button and is switched off by pressing the F1
button for at least five seconds. If the device is in standby mode, this is indicated by the flashing of the green
LED (three seconds off/one second on).
Via the ACD TerminalSettings application it is possible to configure the following combinations to switch the
device on and off:
Setting
No key
F1
Switch
F2
on
OK
(ATX on)
OK+F1
OK+F2
No key
Switch
F1
off
F2
(ATX off)
OK
Figure 2: Front of the device

4.1.2 By Ignition

The hardware of the ignition is explained in chapter 4.3.1.
The ignition can be used via an additional signal (voltage supply cable).
The ignition is used in "parallel" to the "By keys" function. Configuration is carried out in the ACD
TerminalSettings application (see document "Android_Handbuch_Administration_Administration_Manual").
By using the ignition signal, the MFT can be started (switched on) or shut down (switched off).
There are two ways to use the ignition signal: continuously switched (ACD TerminalSettings: "Static") or
button (ACD TerminalSettings: "Toggle"). For the steady state On or Off, a debounce time of 0.5 seconds is
effective.
Static: With an active signal from the ignition the MFT is switched on. Subsequently, the signal must remain
active. When the signal is removed (signal state low) the MFT is shut down.
Toggle: With an active signal from the ignition (longer than 0.5 seconds) the MFT is switched on.
Subsequently, the signal can be inactive (low state). Via another active state (longer than 0.5 seconds) the
MFT is shut down.
Upon delivery of the MFT by ACD, the ignition is configured as requested by the customer.
MFT10_Brief Overview_Resumen_breve_FCC_V1.00_en_es
Function
Immediately switched on without pressing any button
Via the F1 button
Via the F2 button
Via the OK button
Via the OK button and simultaneous after this pressing of the
F1 button within 2 seconds. (The OK button must be kept
pressed while doing so)
Via the OK button and simultaneous after this pressing of the
F2 button within 2 seconds. (The OK button must be kept
pressed while doing so)
No shutdown via any pressed button
By pressing the F1 button for at least 5 seconds
By pressing the F2 button for at least 5 seconds
By pressing the OK button for at least 5 seconds
7 / 40