Vyaire SpiroUSB Manual De Funcionamiento página 59

Guidance and Manufacturer's Declaration – Electromagnetic Emissions
The SpiroUSB is intended for use in the electromagnetic environment specified below.
The customer or the user of the SpiroUSB should assure that it is used in such an
environment
Emission Test
RF emissions
RF emissions
CISPR 11
Harmonic emissions
IEC61000-3-2
Voltage fluctuations/
flicker emissions
IEC61000-3-3
Guidance and Manufacturer's Declaration – Electromagnetic Immunity
The SpiroUSB is intended for use in the electromagnetic environment specified below.
It is the responsibility of the customer or the user of the SpiroUSB should ensure that
it is used in such an environment
Immunity IEC 60601
Test test level
Electrostatic ± 6 kV contact
discharge ± 8 kV air
(ESD)
IEC61000-4-2
Electrical fast ± 2 kV for
transient / power supply
burst lines
IEC61000-4-4
± 1 kV for
input / output
lines
Surge ± 1 kV line(s)
IEC61000-4-5 to line(s)
± 2 kV line(s)
to earth
Compliance
Group 1
Group B
Not Applicable
(USB powered)
Not Applicable
(USB powered)
Compliance
Level
± 6 kV
contact
± 8 kV air
Supply line
tests not
applicable
± 1 kV for
USB lead
Not
Applicable
(USB
Powered)
Electromagnetic Enviroment -Guidance
The SpiroUSB uses RF energy only for
its internal function. Therefore, its RF
emissions are very low and are not likely to
cause any interference in nearby electronic
equipment
The SpiroUSB is suitable for use in all
establishments, including domestic
establishments and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes
Electromagnetic Enviroment-
Guidance
Floors should be wood, concrete or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
of a typical commercial or hospital
environment.
59