Bulb Assembly - Workzone 47625-15 Manual Del Usuario

Dual halogen worklight with stand
TO INSTALL HALOGEN BULB INTO LAMP HEAD
The halogen bulb is shipped in a protective box inside the lamp head.
1. Remove the center screw at the top of the lamp head and lower the hinged
frame with glass lens.
2. Remove bulb from its box and wrapper, being careful not to touch the bulb
with your bare hands. Only use clean cloth or tissue to handle the bulb. Hold
the bulb at its center with a clean cloth or tissue. See Fig. 5
3. Use bulb wrapper or clean cloth to carefully grasp the bulb, and gently push
one ceramic end of the bulb into the bulb holder to engage right side first.
See Fig. 5.
4. Insert the other ceramic end of the bulb into the other bulb holder socket.
Make sure that the bulb makes secure contact at both sockets. When
properly installed, the bulb can be rotated about 45° (1/8 of a turn) on its axis
with very little or no resistance.
5. Close the lens cover and tighten the lens cover screw before turning on the
light.
6. Repeat these steps for the other lamp head.
AFTER SALES SUPPORT
1 866 558 8096
Fig. 5
MODEL: 47625-15 PRODUCT CODE: 47625

Bulb Assembly

[email protected]
05/2015
9