Workzone 47625-15 Manual Del Usuario página 7

Dual halogen worklight with stand Assembly
Step 1: You must unscrew the lens cover in order to have an enough space to insert
the wire lens guard into the four corners around lens cover. See Fig. 3 (1)
Step 2: The wire lens guard must be inserted in between the lens cover and glass
lens. See Fig. 3 (2)
Step 3: Screw the lens cover back on to lamp head and tighten it gently. See Fig. 3 (3)
Fig. 3 ( 3 )
Fig. 3 ( 1 ) Fig. 3 ( 2 )
TRIPOD ASSEMBLY
The tripod comes folded and requires no assembly. To unfold the tripod, unscrew to
loosen the black support knob located at the top of the tripod where the three tripod
legs meet. At the same time, move the support legs away from the center tube of
the tripod and push down on the center leg connector to extend the three legs. The
legs should be extended until they are flat. Re-tighten support knob. Next, adjust the
height of the center pole. To adjust height, loosen the black twist collars on the tripod
and raise the pole sections. Firmly tighten the twist collars once you have adjusted
the center pole to the desired height. See Fig. 1 or refer to image on package.
Finally, set the portable stand with lamp heads onto the tripod then insert the
threaded knob through the washer then through the center handle. Gently thread
into the top of the tripod and tighten securely, do not over tighten. To remove the
portable stand, unscrew the threaded knob at the top of the tripod and lift off the
portable stand.
AFTER SALES SUPPORT
7
[email protected]
1 866 558 8096
MODEL: 47625-15 PRODUCT CODE: 47625 05/2015