Playing A Disc - Philips LX3900SA Manual De Instrucciones

Wireless Receiver Setup
1
5
4
table stand

Playing a disc

Make sure your DVD system and
TV are connected and turned on!
1
Press DISC on the remote control.
You can also press the SOURCE button on the front panel
until "DISC" appears on the display panel.
2
Turn on the TV and select the correct Video
In mode.
You should see the blue DVD background screen on the TV
(if no disc in the DVD system).
3
Press OPEN•CLOSE 0 on the front of the
DVD system and load a disc, then press
OPEN•CLOSE 0 again to close the disc tray.
Make sure the disc label is facing up. For double-sided discs,
load the side you want to play face up.
4
Playback will start automatically.
If a disc menu appears, use 3 4 1 2 buttons on the remote
to make the necessary selection, then press OK to confirm.
Or, use the numeric keypad on the remote to select
features. Follow the instructions given in the disc menu.
5
To stop playback, press STOPÇ.
Rear Speaker
(Right) (Left)
2
3
Detailed playback features and additional functions are described in the
accompanying owner's manual.
Wireless System - Getting Started
1
Turn on your DVD system and play an audio CD
(see 'Playing a disc").
2
Select same transmission frequency channel for
both the wireless transmitter and receiver.
The wireless system will automatically turn on when receiving an audio
signal and vice versa.
On the wireless transmitter :
The default preset frequency is (1). To select
another transmission frequency, press and hold
SOUND button on the remote until "FREQ X"
("X" = 1~4) appears on the DVD system
display panel. Repeat the step again until you
get the best frequency that obtains optimal
reception.
On the wireless receiver :
Adjust the Frequency Selector Switch 1~4
(fig 1), so that both units are using the same
transmission frequency.
TIPS:
– In case of sound distortion, please select another frequency for both the wireless
transmitter and receiver. The distortion could be the result of interference caused by
other equipment using same frequency channel in your house or neighborhood.
– Extend the antennas vertically to improve the reception. Check the antennas
are safely positioned without obstructions.
To ensure quality sound production and transmission:
Place both the wireless transmitter and receiver at least 3 metres apart and off
the ground (recommended minimum height of 30cm). Do not place them too
close to TV, AC power adaptor or any radiation sources.
Also note that audio may be interrupted due to the reflected waves when a
person crosses or approaches the space between the transmitter and wireless
speaker.
No picture?
Check the AV (Audio/Video) mode
on your TV.
* Usually this channel is between the lowest
and highest channels and may be called
FRONT, A/V IN, or VIDEO.
* Or, you may go to channel 1 on your TV,
then press the Channel down button
repeatedly until you see the Video In
channel.
* Or, your TV remote control may have a
button or switch that chooses different
video modes.
* See your TV manual for more details.
/
SOUND
1
1 4
2
ALL ALL
SUPER VIDEO