End Programming; Display Messages - V2 JEDI-700 Manual Del Usuario

10. End programming

To exit the programming and store the settings of the different parameters, it is necessary to follow this procedure:
Press the + key until the
I
display shows
MEMORISING REMOTE CONTROL UNITS
The device can memorise up to 15 remote control units. To memorise a remote control unit, proceed as follows:
Press the key
DELETING REMOTE CONTROL UNITS
Press and hold key :

DISPLAY MESSAGES

Display Reason
The display shows the letter L when the actuator is working normally and the red cam positioned on the chain activates
L
the micro switch on the motor
F The display shows the letter F when the door encounters an obstacle
H The display shows the letter H when the encoder or the control unit is malfunctioning
A The display shows the letter A when the photocell intervenes
Press and hold the key
I
for 5 seconds: flashes
0
appears on the display
after approx. 1 second
0
appears on the display
after approx. 1 second
Release the key: the
segments of the display
illuminate one at a time
0
until showing
Release the key and press the remote control button
twice: the device emits a BEEP and the display is turned
off to confirm memorising has been successful
Hold the key until the display is turned off : the remote
controls have been deleted.
23