DITTING 807 Serie Instrucciones De Uso página 51

Problem Cause
The grinder is • The power plug is
not grinding or
buzzing.
• The bean hopper
• The thermal
• The electric fuse
The grinder's
dispensing
accuracy is
decreasing.
The grinder is • The grinding discs
not grinding
fi nely enough.
• The grinding discs
not plugged into a
socket.
is not
inserted.
overcurrent cir-
cuit-breaker has
been triggered.
has tripped.
• The fl apper is
dirty.
• The fl apper is
faulty.
are worn out.
are not aligned
correctly.
Remedy
Insert the power plug into a prop-
erly installed wall socket.
Insert the bean hopper (see "Set-
ng up the grinder and inser ng
the bean hopper" sec on).
Check whether the overcurrent
circuit-breaker's release bu on
has popped out.
Push it back in if necessary. If
the overcurrent circuit-breaker
repeatedly pops out, contact your
supplier (see "Maintenance and
service" sec on).
Check the electric fuse.
Return it to its original state or
replace it.
Check whether other loads are
connected to this fuse and if so,
pull their plugs.
If the back-up fuse trips repeat-
edly, contact your supplier (see
"Maintenance and service"
sec on).
Clean the fl apper (see "Cleaning
the fl apper" sec on).
Change the fl apper (see "Chang-
ing the fl apper" sec on).
Contact your supplier
(see "Maintenance and service"
sec on).
Contact your supplier
(see "Maintenance and service"
sec on).
807 | EN 807
51 51