Cleaning The Grinding Mechanism - DITTING 807 Serie Instrucciones De Uso

Cleaning the fl apper/changing the fl apper
• The fl apper should be cleaned every 2–5 days.
• Change the fl apper when it becomes porous, deformed or
very dirty.
1. Remove the bean hopper (1) and proceed as described in the "Cleaning
the bean hopper" sec on, steps 1–4.
2. Remove the fl apper (16) through the opening in the integrated grinder
(Fig. D, 18).
3. Clean the fl apper with lukewarm water and then dry it.
Or change the fl apper.
4. Posi on the fl apper in the opening in the integrated grinder.
5. Posi on the bean hopper on the grinder (see "Cleaning the bean hopper"
sec on, steps 6–8).

Cleaning the grinding mechanism

• The manufacturer recommends using the GRINDZ
cleaner. For more informa on about GRINDZ
di ngswiss.ch.
• The grinding mechanism should be cleaned every 2–5 days.
1. Grind the coff ee beans that remain in the grinding mechanism un l the
grinder runs idle and no coff ee beans are le in the bean hopper (1).
2. Use the grind adjustment (2) to set the coarsest possible grinding degree
(see "Se ng the grinding degree" sec on).
3. Pour the grinder cleaner into the bean hopper.
Use only the quan
cleaner you are using.
4. Place a collec ng container underneath the spout (6) to collect the grinder
cleaner.
5. Press the start bu on (3) to start grinding the grinder cleaner.
The grinding of the grinder cleaner is completed as soon as the grinder
begins to idle.
6. Switch off the grinder by pressing the start bu on once the grinding clean-
er has been completely ground.
7. Wipe down the bean hopper with a dry, lint-free cloth.
8. Remove any le over cleaning par cles by grinding the same amount of
coff ee beans as the grinder cleaner used. Set the grind to the desired set-
es indicated by the manufacturer of the grinder
807 | EN 807
TM grinder
, visit www. TM
47 47