Uline H-2957 Manual De Usuario página 8

CtL MENU
SUB-
CODE NAME/DESCRIPTION
CODE
Fr1
CHCF
Cd1
FUn MENU
SUB-
CODE NAME/DESCRIPTION
CODE
rPt- ACC
dEC
brA
Stt- Stt
rrS
AdC- AdC
SdC1
tdC1
PSS- PS2
SP2
CLI- CL1
SPL- LSP
HSP
PAGE 8 OF 51
FREQUENCY DRIVE CONTINUED
Speed Reference Channel 1:
Al1 – Terminal analog input
LCC – Remote Display
Ndb – Modbus
AIU1 – Jog dial (wheel) on drive
Channel Configuration:
SIN – Not separate mode. Speed and run commands from the same source.
SEP – Separate mode. Speed and run commands from different sources.
Command Channel 1 (run fwd/rev, stop):
Only appears if CHCF is set to SEP.
tEr – terminals
LOC – Local
LCC – Remote display
Ndb – Modbut
Acceleration Time (seconds)
Deceleration Time (seconds)
Decel Ramp Adaptation Assignment:
nO – Function inactive. (Used with dynamic braking)
YES – Automatically increases the deceleration time to prevent a DC bus overvoltage
dYnA – Most rapid deceleration possible without a dynamic braking resistor.
Type of Stop:
rNP – Ramp Stop
FSt – Fast Stop
nSt – Freewheel
Reverse Direction Assignment:
nO – Function inactive
L1H – Input L1 active high
L2H – Input L2 active high
L3H – Input L3 active high
L4H – Input L4 active high
Automatic DC Injection:
nO – function inactive
YES – Time limited DC injection
Ct – Continuous DC injection
Automatic DC Injection Current
Automatic DC Injection Time (seconds)
Second Preset Speed Assignment:
nO – Function inactive
L1H – Input L1 active high
L2H – Input L2 active high
L3H – Input L3 active high
L4H – Input L4 active high
Second Preset Speed Reference
Current Limitation
Low Speed Setting (Hz)
High Speed Setting (Hz)
FACTORY
SETTING
Al1
SIM
tEr
ADJUSTMENT FACTORY
RANGE SETTING
0.0-999.9 s 3.0 s
0.0-999.9 s 3.0 s
YES
rNP
nO
YES
0-120% if nCr 70%
0.1-30 s 0.5 s
nO
0-400 Hz 10 Hz
0.25-1.5 plate varies
0-HSP 0 Hz
LSP-tFr 60 Hz
0120 IH-2957