GE PSB42 Manual Del Propietario E Instrucciones De Instalación página 21

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

STEP 3 INSTALL WATER LINE
(Cont.)
SmartConnect
in the following lengths:
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the
line of water.
valve and cold water pipe in a basement or cabinet.
The shut-off valve should be located where it will be
easily accessible.
• Turn on the main water supply and flush debris.
Run about a quart of water through the tubing into
a bucket. Shut off the water supply at the shut-off
valve.
NOTE: Saddle type shut-off valves are included in
many water supply kits. Before purchasing, make sure
a saddle type valve complies with your local plumbing
codes.
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.
STEP 4 WATER LINE
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM OR OTHER
HOUSEHOLD FILTRATION SYSTEM
Skip this step when not using an RO System or
other household filtration system.
household filtration system, use the refrigerator's filter
bypass plug. Using the refrigerator's water filtration
cartridge with the RO filter can result in hollow ice
cubes.
Rotate Counterclockwise
to Remove
49-1000364 Rev. 1
Installation Instructions
Filter Bypass
Plug
STEP 5 INSTALL SIDE PANELS
Skip this step when not using side panels.
should be inserted into the case trim. Fasten the
panels to the refrigerator with stick-on hook and loop
fastener strips before setting the refrigerator in place.
STEP 6 ANTI-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially with
any doors open, and must be secured to prevent
tipping forward which could result in death or
serious injury. Read and follow the entire installation
instructions for securing the refrigerator with the
anti-tip system.
long and secure
the block to the
mounting brackets
provided using #12
or #14 wood screws.
• Secure the bracket
with wood block to
the back wall so that
from the finished
floor. Use #12 or
#14 wood screws. See the illustration.
Tip Over Hazard.
21
Tabla de contenido
loading

Este manual también es adecuado para:

Psb48

Tabla de contenido