Troubleshooting - Briggs & Stratton 26CC Manual Del Usuario

PROBLEM
Engine will not start
Insufficient power
Engine stops during operation
Engine is difficult to stop
Unit main body
Pump is no spraying
Insufficient spray pressure
If running difficulties continue, contact your closest Authorized Dealer or Service Centre.

TROUBLESHOOTING

LOOK FOR
Electrode spark plug is wet or fouled
Cracked spark plug insulator
Incorrect spark plug gap
Engine flooded
Incorrect or stale fuel
No fuel in tank
Clogged air filter
Fuel line/passage clogged
Carbon build up in muffler
Use incorrect or stale fuel
Piston seizure
Machine is overworked
Switch is bumped
Shorting of spark plug
Piston scored
Fuel tank is empty
Carburettor or fuel tank clogged
Stop wire disconnected from the switch
Overheated engine
Loose engine and/or pump mounts
Tank leak
Leak at the tube connections
No chemical diluted liquid in the sprayer tank
Valves inside the pump clogged
Cock valve blocked
Incorrect pressure setting - too low
Pump is worn out or damaged
Spray wand nozzle clogged
Pump speed or pressure setting too low
Spray wand nozzle clogged
Pump seals and/or vee-packing seals worn or damaged
One way valve(s) inside the pump clogged
Clutch slipping
Lack of lubrication
Burst spray hose
Spray wand nozzle worn or damaged
REMEDY
Clean or replace the spark plug
Replace the spark plug
Adjust gap 0.6 - 0.7mm
Crank engine with choke open and full throttle to clear excess
fuel
Drain and replace with correct fuel/oil mixture
Refuel with correct fuel/oil mixture
Clean and lubricate air filter
Contact Service Centre or see Authorized Dealer
Contact Service Centre or see Authorized Dealer
Drain and replace with correct fuel/oil mixture
Contact Service Centre or see Authorized Dealer
Operate properly - do not overload
Restart the engine
Clean spark plug or replace
Contact Service Centre or see Authorized Dealer
Refuel with correct fuel/oil mixture
Contact Service Centre or see Authorized Dealer
Attach stop wire to switch
Contact Service Centre or see Authorized Dealer
Retighten engine and/or pump mount screws
Contact Service Centre or see Authorized Dealer
Retighten the hose clip or replace if damaged
Fill the sprayer tank
Contact Service Centre or see Authorized Dealer
Clean the cock valve or replace
Adjust the pressure regulation dial
Contact Service Centre or see Authorized Dealer
Clean the nozzle
Adjust the pump speed and pressure regulation dial
Clean the nozzle
Contact Service Centre or see Authorized Dealer
Contact Service Centre or see Authorized Dealer
Replace the clutch
Apply grease onto the plunger
Contact Service Centre or see Authorized Dealer
Contact Service Centre or see Authorized Dealer
ENGLISH
23