AquaPRO 53041-0 Manual Del Usuario página 6

Drop-in pump application
Pull across pump installation
To aid in pump placement on pool cover, secure provided 25 ft. rope to the pull to shore loop( Figure B).
C1. Connect provided 25ft. rope to pull to shore loop (Figure B).
C2. Place pump on pool cover near edge of pool (Figure C).If flotation device is used, place pump at the lowest point on
the pool cover where water will collect.
Pull across- pump removal
6
A1. Place hose end away from pool, where water will be
displaced.
A2. Attached provided 25ft. rope to handle of pump, and
lower pump onto pool cover where water will collect.
A3. Do not exceed the 13ft. maximum pumping height for
this pump or switch may not function properly. Plug in pump
to allow for automatic operation.
For removal unplug pump and retrieve using rope.
D1. Holding the provided 25 ft. rope, walk around pool until
you are even with the pump on the opposite side.
D2. Pull the 25 ft. rope towards you until the pump is in the
center of the pool cover where water will collect. Secure
rope for easy removal (Figure E) when weather permits.
Note: Always use debris strainer when placing pump on a
pool cover. The strainer helps protect the pool cover from
damage, filters debris, and increases pump stability.
E1. Disconnect power to pump. Using the included 25ft.rope,
safely pull pump to edge of pool, disconnect discharge hose
and remove.
For Professional Technical Support call 1-844-242-2475