Test Rangetop Burners; Flame Characteristics; Test Oven Burners - Siemens HG2425UC Instrucciones De Instalación

1. Turn on Power at Breaker
If LCD screen flashes and beeps continuously, the wiring is
incorrectly installed. Verify that wiring in house is correctly
installed. If house wiring is correct so, call Siemens
Service.

2. Test Rangetop Burners

Test Burner Ignition. Select a rangetop burner knob.
Push down and turn to the flame symbol. The ignitor/spark
module will produce a clicking sound. Once the air has
been purged from the supply lines, the burner should light
within four (4) seconds.
Test Flame: High Setting. Turn burner on to HI. See
Figure 7 for appropriate flame characteristics.
If any of the burners continue to burn mostly or completely
yellow, call Siemens Service.
Test Flame: Low Setting. Turn burner on to LO. Verify
that the flame completely surrounds the burner. There
should be a flame at each burner port and there should be
no air gap between the flame and the burner. If any of the
burners do not carry over, call Siemens Service.
Test the ignition and flame of each rangetop burner as
described above.
WHEN FLAME IS PROPERLY ADJUSTED:
There should be a flame at each rangetop
burner port.
There should be no air gap between the
flame and the burner port.

3. Test Oven Burners

Remove the oven bottom cover. Remove the two
rear thumb screws, slide cover forward and out.
Test Bake Burner Ignition. Set the oven to bake at
350° F. After 30-75 seconds, the burner will ignite.
The burner will stay lit until the 350° F is reached and
then shut off. From this point forward, the burner will
cycle on and off to maintain the temperature.
Test Bake Burner Flame. While the burner is lit,
inspect the flame. See Figure 7 for proper flame
characteristics. If the flame burns completely or
mostly yellow, adjust the bake burner air shutter. See
Figure 8 (next page) for details.
Test Broil Burner Ignition. Set cooking mode to Hi
Broil. The burner will ignite after 30-75 seconds.
Test Broil Burner Flame. While the burner is lit,
inspect the flame. See Figure 6 for proper flame
characteristics. If the flame burns completely or
mostly yellow, adjust the broil burner air shutter. See
Figure 8 (next page) for details.
Replace oven bottom cover. Slide cover into place
and replace two rear thumb screws.
Step 6: Final Steps - Test Burner Function

Flame Characteristics

Yellow Flames:
Further adjustment is required.
Yellow Tips on Outer Cones:
Normal for LP Gas.
Soft Blue Flames:
Normal for Natural Gas.
If the flame is completely or mostly yellow, verify that the
regulator is set for the correct fuel. After adjustment, retest.
Some yellow streaking is normal during the initial start-up.
Allow unit to operate 4-5 minutes and re-evaluate before
making adjustments.
Figure 7
Call Siemens Service 866-447-4363 if:
1. Any of the burners do not light.
2. The broil burner or bake burner flame goes
out before either reaches temperature.
3. Any of the burners continue to burn yellow.
If flame adjustment is necessary, continue to next
page. Otherwise, installation is complete at this point.