Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Step 3
Attach Kick Bar
1. Locate the kick bar and position it between
the left and right wheel assemblies as
shown in figure C.
2. Place one (1) 10 mm star washer onto one
(1) 10 mm x 50 mm hex head bolt. Insert
bolt through the leg/wheel assembly and
thread it into the the kick bar and securely
tighten.
Repeat this procedure on other side.
Step 4
Attach Table Top
1. Locate the table top and position holes in
end of table top with holes in upper cross
bar as shown in figure D.
2. Place one (1) flat washer onto one (1) 10
mm x 100 mm bolt.
3. Insert bolt through table top and place
another (1) flat washer on bolt between
table top and upper cross bar.
4. Insert bolt through upper cross bar, place
one (1) flat washer, and loosely tighten
with one (1) 10 mm lock nut.
Note: Do not over-tighten lock nut - these
parts need to freely rotate for stand to
operate properly.
Repeat this procedure on opposite side.
Step 5
Attach Linkage Bars
1. Align hole in upper linkage bar with hole in
table top as shown in figure E.
2. Place one (1) flat washer onto one (1) 10
mm x 100 mm bolt.
3. Insert bolt through linkage bar and place
another (1) flat washer on bolt between
table top and upper cross bar.
4. Insert bolt through table top, place one (1)
flat washer, and loosely tighten with one
(1) 10 mm lock nut.
Note: Do not over-tighten lock nut - these
parts need to freely rotate for stand to
operate properly.
Repeat this procedure on opposite side.
FIG. C
FIG. D
Lock Nut
Upper
Cross Bar
Washer
FIG. E
Lock Nut
Table Top
Washer
-5-
Table Top
Washer
Washer
Linkage
Bar
Washer
Washer
Bolt
Bolt
Tabla de contenido
