Tabla de contenido
SET UP
CHARGING YOUR EARPHONES
The "Tune In" earphones are powered by a
rechargeable battery. Please make sure to charge
earphones before use.
A – Unwrap the integrated charging cable and plug
the micro USB end into the charging port on the
earphones.
B – Connect the larger USB plug to your computer
or a powered USB AC adapter. An AC adapter is not
included in the box, but you can use the one for your
cell phone or pick one up next time you're at the
store.
C – When the LED flashes red, it indicates that the
battery is low and it's time to plug in and recharge.
Charge for about 2 hours to get up to 12 hours of play
time; while charging, the light will stay solid red.
Once fully charged, the LED will turn off.
USE
A – TURN ON YOUR EARPHONES
Hold down the power button for 3 seconds to turn on
your earphones.
B – CONNECTING TO A DEVICE
Once turned on, the earphones will immediately search
for a device to pair to; the LED will blink red and blue
alternately. Enable Bluetooth on your device. From the
Bluetooth menu, select "Tune In". When the device and
Tune In are connected, you will hear a tone and the
LED light will turn solid blue.
You may also connect your device to Tune In using an
aux cord, which is not included. When plugged in, the
light will turn solid red.
Once paired, your device and earphones will find each
other every time, as long as your device's Bluetooth is
on. If you're connecting to a computer, you may have
a few more steps on that end. You'll have to get that
information from the computer company.
3
Depending on your device, you may be prompted to
enter a pairing code. If so, use "0000" as the code.
Holding down the "X" and "O" buttons at the same
time, for 5 seconds, will disconnect a paired device.
EN
Tabla de contenido
