Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1.1.10 Do not use the equipment outdoors.
1.1.11 Do not expect your blender to replace any other
kitchen appliance. It is not supposed to make mashed
potatoes, it does not blend egg white or any other cream
for covering, it does not grind raw meat, it does not blend
hard pastas and does not extract kernels from fruit and
vegetables.
1.1.12 The blender works in seconds and not in minutes.
Therefore, never let your blender working for more than
one minute. It is better to switch it off and check the mixing
consistency after a few seconds to avoid over blending.
1.1.13 Do not overload the motor with big or heavy
portions, once it will decrease the blender's lifespan. If the
motor stops, immediately switch it off, unplug and remove
part of the load before restarting the operation
1.1.14 For your safety the temperature of the product shall
not be above 40 degrees centigrade.
This Equipment cannot be operated by persons
(children included) with reduced mental, sensorial or
physical capacities. Unexperienced persons or persons
without proper training of knowledge on how the
equipment works cannot operate this equipment. Only
apt and trained persons or persons under the supervision
of an apt and trained supervisor must operate the
equipment.
We recommend children to be watched to not allow
them to play with the machine.
Always disconnect the Equipment from the power
supply when: It is not being used, before realizing any
cleaning or maintenance, before you place or take out any
accessories, before you realize any kind of procedure or
service with the unit.
Do not use the Equipment if there is any damage to
the cord or plug. Make sure that the cord does not stay
on the edge of a working table, station or furniture and
make sure it is not in contact with hot surfaces. If the Cord
is not in good conditions of use, to avoid accidents it must
be replaced by the supplier, an authorized technician or
someone qualified for the service.
If any emergency arises disconnect the Equipment
from the power supply, unplug it from the electrical socket
Never spray water directly on to the equipment.
2. COMPONENTS AND TECHNICAL FEATURES
Picture 01
02
05
01 – Cap
02 – Lid
03 – Cup
Maximum Cup Capacity
.
3. INSTALLATION AND PRE-OPERATION
3.1 Placement of the equipment
The Equipment must be placed and levelled on top of a firm
and dry Surface, preferably with 850mm of height.
3.2 Electrical Installation
This Equipment was designed to work in the following
voltages and frequencies: 110 or 220 (50 ~ 60Hz). After
unpacking the equipment, check the voltage informed on
the tag placed at the electrical cord.
The plug has 2 pins, the central hole is the ground wire. It is
mandatory that all pins be connected to the power supply
before the equipment is turned on.
3.3 Pre-Operation
•
Make sure that the equipment is firm and levelled on
its working place.
•
Before using the equipment, all parts that will get in
contact with food must be washed with water and
neutral soap.
3.3.1 Procedure to Assemble the Cup
1 - Place the sealing ring
#01 on the central bearing
#02 (Pic. 02).
01
2 - Fit the central bearing
#02 plus the sealing ring
#01 in the cup's base #03
(Pic. 02).
03
3 – Thread the cup #04 in
the cup's base #03 (Pic. 02)
04
3.3.2 Placing the Cup
The Cup #04 (Pic. 02) has a versatile fitting system allowing
06
an easy, quick and safe placing.
To remove or to place the Cup #03 (Pic.01) just lift it using
04 – Housing
05 – ON/OFF/Pulse Switch
06 – Feets
FEATURES
Voltage
Frequency
Height
Width
Depth
Net Weight
Gross Weight
Power Rating
Picture 02
UNIT
LI2
L
2
V
110 or 220
Hz
50 ~ 60
mm
420
mm
200
mm
190
kg
2,17
kg
2,52
W
900
06
05
04
01
02
03
3
Tabla de contenido
