Whirlpool W11256524A Instrucciones Para El Usuario página 18

Problem Possible Causes and/or Solutions
Power failure (display shows flashing time): Clear the display. On some models, reset the clock,
Display shows
if needed. See "Clock" keypad feature in the "Feature Guide" section.
messages
Error code (display shows letter followed by number): Depending on your model, press CANCEL to clear
the display. See "Control Display" in the "Electronic Oven Controls" section. If it reappears, call for service.
See the "Warranty" for contact information
Start needs to be pressed so a cycle can begin (display shows "PUSH" or "PSH"): See the Start keypad
feature in the "Feature Guide" section.
Range is in Sabbath mode (display shows "SAb"): Press CANCEL to exit Sabbath mode.
Clean cycle did not
Several cooking cycles between clean cycles or spills on oven walls and doors: Run additional
work on all spills clean cycles. Use the AquaLift
Cleaner can be used for stubborn soils.
Tap water was used in the clean cycle: Use distilled or filtered water in the clean cycle.
Mineral deposits
are left on the oven
To remove deposits, use a cloth soaked with vinegar. Then use a cloth dampened with water to
bottom after the
thoroughly remove any vinegar residue.
Clean cycle
Range is not level: Mineral deposits will collect on dry areas of the oven bottom during the clean
cycle. Level the range. See the Installation Instructions.
To remove deposits, use a cloth soaked with vinegar. Then use a cloth dampened with water to
thoroughly remove any vinegar residue.
Range is not level: Level the range. See the Installation Instructions.
Oven cooking results
not what expected
The set temperature was incorrect: Double-check the recipe in a reliable cookbook.
Oven temperature needs adjustment: See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
Oven was not preheated: See "Baking and Roasting" section.
Racks were positioned improperly: See "Positioning Racks and Bakeware" section.
Not enough air circulation around bakeware; See "Positioning Racks and Bakeware" section.
Darker browning of food caused by dull or dark bakeware: Lower oven temperature 25°F (15°C),
or move rack to a higher position in the oven.
Lighter browning of food caused by shiny or light colored bakeware: Move rack to a lower position
in the oven.
Batter distributed unevenly in pan: Check that batter is level in the pan.
Incorrect length of cooking time was used: Adjust cooking time.
Oven door was not closed: Be sure that the bakeware does not keep the door from closing.
Oven door was opened during cooking: Oven peeking releases oven heat and can result in longer cooking
times.
Rack is too close to bake burner, making baked items too brown on bottom: Move rack to
higher position in the oven.
Pie crusts browning too quickly: Use aluminum foil to cover the edge of the crust and/or reduce
baking temperature.
Noises
Problem
Surface burner making popping noises Wet burner: Allow it to dry.
Gas range noises during Bake and
Broil operations
The following are some normal sounds
with the explanations.
Pop
Click
Woosh or poof
Oven burner flames are yellow or noisy Range converted improperly: If Propane gas is being used, contact a service technician
Technology Cleaning Kit. Kitchen and Appliance Cleaner or Cooktop
®
Possible Causes and/or Solutions
These sounds are normal operational noises that can be heard each time the bake
or broil burners ignite during the cycle.
Gas valve is opening or cycling on and will make a single pop when it snaps open
from the solenoid. It sounds similar to a suction cup being pulled off of a piece of
glass: This is normal.
The igniters will click several times until the flame is detected. These are short
clicking sounds like tapping a nail onto a piece of glass: This is normal.
Convection fan relay is cycling on and off (on some models): This is normal.
Bake or broil burner is igniting: This is normal.
or see the "Warranty" for contact information.
18