Technical Features; Combustion Air - EdilKamin Evolution Serie Instalación Uso Y Mantenimiento

COVERINGS
CHIC: amber, red, zest-white.
ELITE: gray varnished steel.
VANITY: ollite.

TECHNICAL FEATURES

• CHIC, ELITE, VANITY stoves are built with a cast iron frame and thick
steel firebox.
• The whole firebox is coated with refractory material ECOKERAM®
All three models are provided with second and third air injections for
cleaning the glass.
• Smoke outlet can be on the upper or on the back side, in order to optimi-
se installation.

COMBUSTION AIR

CHIC, ELITE and VANITY stoves use two different operating modes to
control combustion air:
A) AUTOMATICO
there are two controls located on the lower grate of the stoves: a switch for the
"automatic" mode and a lever for "manual" control.
Manual mode: Position the switch "S" to MANUAL, fully inserted in the cast iron grate; the control lever "L"
controls the amount of air and therefore the strength of the flame from minimum (lever positioned on the left) to
maximum (lever positioned on the right).
Automatic mode: Position the switch "S" to AUTOMATIC, fully withdrawn from the grate; the lever "L" must be moved fully left. In
this way, thanks to a thermostatic valve, the stove will automatically adjust the strength of the flame according to the temperature of the
firebox: when the firebox is cold, for example on ignition, the valve will allow the maximum amount of air in to facilitate this stage; as
the temperature in the firebox increases, the valve will slowly decrease the amount of air allowed in, preventing overheating in the room
where the stove is installed and excessive and unnecessary consumption of wood."
HEATING AIR
These stoves are available in two versions:
• with heating air circulation and natural convection (N),
• with forced ventilation circulation (V).
The version V is supplied with a 800 m3/h fan, which can be adjusted from the synoptic panel.
CONVEYING THE HEATING AIR
The ventilated versions of CHIC, ELITE, VANITY wood-burning stoves allow conveying hot air to adjacent rooms. On the rear of
the stoves there are two Ø10 cm male ducts for conveying hot air. If you want to heat only one adjacent room (fig. A) you will need
to use a KIT 8 applying it on one of the two ducts. In order to send 100% of the hot air in the adjacent room, you will have to use a
KIT 9 (fig. C) (use of only one air grille). If you want to heat 2 adjacent rooms you must use two KIT 8 (fig. B) to be applied on
both ducts.
For only one
adjacent room
1 KIT 8
Fig. A
B) MANUALE
For two adjacent
rooms use
2 KIT 8
- 15
HOT AIR CIRCULATION
1 air inlet
2 outlet for hot air conveyable to adjacent rooms
3 outlet for hot air in the room
4 upper smoke outlet
5 rear smoke outlet
Fig. B
-
For one adjacent
room use
1 KIT 9
Fig. C