Angelcare AC1320 El Manual Del Propietario página 4

12.13 Power Sources - Operate this product only
from the type of power source indicated on the
type plate of the adaptor. If you are unsure of the
type of power supply to your home, consult your
dealer or local power company.
12.14 Overloading - DO NOT overload wall
outlets, extension cords or integral convenience
receptacles as this can result in a risk of fire or
electric shock.
12.15 Object and Liquid Entry - NEVER push
objects of any kind into this product through
casing slots as they may touch dangerous voltage
points or short out parts that could result in a risk
of fire or electric shock. NEVER spill liquid of any
kind on the product.
12.16 Antenna - The antenna used for this
transmitter must be installed to provide a
separation distance of at least 7.9'' (20 cm)
from all persons and must not be collocated or
operating in conjunction with any other antenna
or transmitter.
12.17 Power Lines - An outside antenna system
should NOT be located in the vicinity of overhead
power lines or other electric light or power
circuit, or where it can fall into such power lines
or circuits as contact with them may be fatal.
13. I M P O R TA N T
RELATED TO USE OF BATTERIES
13.1 Use ONLY the type and size of batteries
specified in the owner's manual. There is a risk
of explosion if batteries are replaced with an
incorrect type.
13.2 Charge the battery for 9 hours prior to first
use. Be sure to have the monitor in the OFF
position during this period. ONLY use the adapters
included with your monitor.
13.3 DO NOT use these adapters with any other
equipments.
13.4 When unplugging the adapter from the
Nursery Unit, be sure it is switched to the OFF
position. If it isn't, the unit will revert to battery
mode if batteries are installed.
13.5 DO NOT use rechargeable batteries in the
Nursery Unit. Use alkaline batteries ONLY.
13.6 DO NOT dispose batteries in fire. They may
explode. Check with local regulations for possible
special disposal instructions.
13.7 Exercise care in handling batteries in order
not to short out the batteries with conducting
materials such as rings, bracelets and keys.
Overcharging, short circuiting, reverse charging,
mutilation, or incineration of batteries must be
avoided to prevent one or more of the following
occurrences: release of toxic materials, release of
hydrogen and/or oxygen, gas and rise in surface
temperature.
13.8 DO NOT attempt to recharge batteries
provided with or identified for use with this
product that are not intended to be charged.
The batteries may leak corrosive electrolyte or
explode.
13.9 DO NOT attempt to rejuvenate the batteries
provided with or identified for use with this
product by heating them. Sudden release of
battery electrolyte may occur, causing burns or
4
S A F E T Y I N S T R U C T I O N S
irritation to eyes or skin.
13.10 If and when necessary, the batteries must
be replaced with identical new ones or equivalent
(volts and size). If a battery to be replaced is
connected with other batteries in series, replace
the other batteries at the same time as well. DO
NOT mix old and new batteries.
13.11 Reverse polarity installation of the batteries
in the end product must be avoided. Reverse
insertion of batteries can cause charging, and
that may result in leakage or explosion.
13.12 Remove batteries from the Nursery Unit if
you store the product over 30 days because the
batteries could leak and damage the product.
13.13 Discard 'dead' batteries as soon as possible
since 'dead' batteries are more likely to leak in a
product. If a battery has leaked or vented, it should
be replaced immediately using protective gloves.
13.14 DO NOT store this product, or the batteries
provided with or identified for use with this
product, in high-temperature areas.
WARNING
(North America Only)
14. Warning: Changes or modifications to this
equipment not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
14.1 NOTE: This equipment has been tested
and found to comply with part 15 of the FCC
Rules and the Industry Canada license-exempt
RSS standard(s). These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
14.2 However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
14.3 This device complies with the part 15 of
the FCC Rules and the Industry Canada license
- exempt RSS standards(s). Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.