Kathrein UFO 331/TP Manual Del Usuario página 24

Note: For COFDM modulation the maximum data rate in the output channel is usually lower than the received
data rate. For this reason the channel fi lter must normally be switched off.
If the channel fi lter is switched on, a display appears next to the parameter indicating the current output data rate. Since the data rate
can vary depending on the channel content, the instantaneous and maximum values are displayed.
Note: Only average values that can vary based on channels are displayed. To ensure error-free functioning and
plan for at least 10 to 15% reserves, i.e. the data rate utilisation should not be above 85 to 90%.
The "Channel fi lter" sub-menu is exited using the "Sub-menu" button
Note: If the maximum possible number of channels carried over is exceeded, an error message appears.
1.13 Transport stream processor: changing IDs
A 1236
27.500 MS/s
Outp. S21
8 MHz
The setting of the "ID" is performed in the TP (Transport stream processor) sub-menu.
The "TP" transport stream processor is selected using the "<" and ">" buttons, and the sub-menu is called up using the "Sub-menu"
button .
The "IDs" function is called up using the "<" and ">" buttons, and the sub-menu is called up using the "Sub-menu" button
Here you can edit the operator ID, the transport stream ID and the original network ID as required.
*** UFO331TP
Filter
IDs
"Transport stream processor" sub-menu
1.13.1 Operator ID (OID)
The "OID" CAT operator ID can be set in the IDs sub-menu. To do so, use the "<" or ">" keys to select "orig" next to the OID
parameter and then use the "+" or "-" to set the "edit" value. The OID value now appears in hexadecimal notation. In the "edit"
setting you can modify the value. To do this, select the value using the ">" key. Use the "+" or "-" key to change the current value
in ± 1 increments. Alternatively you can also select numeric setting mode by pressing the
can be modifi ed by pressing the "+" or "-" keys in ± 1 increments. The values available are "00h" to "FFh".
MHz
3/4
306.00
QAM64
Main menu
on
CI
.
TP ***
QPSK Filter
MHz IDs
!
*** ***
OID
TSID
ONID
10 / 14
UFO331TP
on
CI
"Transport stream processor" sub-menu
UFO331TP
orig
orig ----h
orig ----h
"IDs" sub-menu
button. In numeric mode each digit
***
62% / 76%
.
***