Measurement; Normal Measurement - A&D Medical PROCONNECT 651 Serie Manual De Instrucciones

Measurement

Normal Measurement

1. Place the cuff on the arm
(preferably the left arm). Sit
quietly during measurement.
2. Press the START button. All
of the display segments are
displayed. Zero is displayed
blinking briefly.
Then the display changes, as
indicated in the figure to the right,
as the measurement begins.
The cuff starts to inflate. It is
normal for the cuff to feel very
tight. A pressure bar indicator is
displayed, as in the figure to the
right, during inflation.
Note: If you wish to stop inflation at any time, press
the START button again.
3. When inflation is complete,
deflation starts automatically
and the (heart mark) blinks,
indicating that the measurement
is in progress. Once the pulse
is detected, the mark blinks with
each pulse beat.
Note: If an appropriate pressure is not obtained, the
device starts to inflate again automatically.
4. When the measurement is complete, the systolic and diastolic
pressure readings and pulse rate are displayed. The cuff
exhausts the remaining air and deflates completely.
5. Press the START button again to turn off the power.
Note: This product is provided with an automatic power shut-off function, which turns the
power off approximately one minute after measurement.
At heart level
Press the START button
All of the display
segments
Zero display
Starts in ation
Pressurizing
Turn o with the
START button
E-16