EN
Precautions:
1) Stability is guaranteed, even with open doors, but it is forbidden to stand on them.
2) Is not recommended to load Internal grids and trays over 40 kg. The load must be evenly
distributed.
3) It is complete forbidden to sit or lean over the drawers.
4) In case of breakdown, it is not allowed to approach the refrigerator barefoot, wet soil or wet
hands.
5.1.4
Switch off the machine
Put the switch in OFF or in O position to switch off the machine, the light will off.
5.2 Useful tips
Read carefully the below advices so as to reach the full potential of the refrigeration cabinet.
5.2.1
Maintenance
Carry out necessary cleaning operation in order to enlarge the service life of the machine.
Remove any waste from the machine at the end of each day. Before cleaning the machine,
unplug the machine from the electricity supply and put the switch in OFF or O position. The
cabinets include a drainage in the bottom of refrigerated chamber, to help the cleaning
operation, as well as the eventual output of liquids from food. During the cleaning operation
it is essential to remove the drain plug and clean it, to prevent clogging by solid elements. It
prevents accumulated liquids from stagnating.
Do not use abrasive, corrosive or acid products, chlorine-based detergents, solvents or
petrol derivatives to clean the machine.
Do not use pressurized water to clean the machine.
Take precautions before accessing to the unit condenser zone, due to the high temperatures
there might be risk of burns
Cleaning the condenser: During cleaning, avoid any bending of the condenser aluminum
fins. It could affect on the condenser air circulation, causing serious damage to the
equipment, being the repair out of warranty in that case.
Check that the doors close perfectly.
If any change of wires is needed, do not change for a lower section one
The assembly of the electrical installation cover in the control panel is important. If
disassembling is needed, it must be tightened back as it was.
Twice a year call the technical service to carry out the relevant revisions:
o Review of the status of the joints.
o Review of the state of the components.
If the wire is damaged, it should be replaced by the manufacturer, its after sales service
department or by an autorized technicial to avoid any personal or equipment damage.
5.2.2
Prolonged non use
If the machine is kept out of service for a long period of time (holidays, temporary closure...), please
observe the following:
Clean the equipment carefully.
Switch off the mains power supply.
26