Configuration Mode - GYS GYSFLASH 50.24 HF Manual Del Usario

Submenu:
• Languages:
This menu enables to select the language (use the arrows to change the
language).
• Automatic restart:
Automatic restart only works with «Showroom» , «Charge» and «Power
Supply» Mode. This feature enables the charger to restart automatically
and to restart charging after a cut in power.
To activate the «Automatic restart» feature « Configuration | Restart :
ON ».
• Lock Showroom:
To lock the device
To activate the «Lock Showroom» feature « Configuration | Lock
Showroom : Y ».
Shortcut to Lock Showroom:
The «Lock Showroom» feature can be activated without accessing the configuration menu.
• Turn off the device (main switch in OFF position)
• Push the MODE key
• Turn on the switch, while the MODE key is still pressed. Within 3s the display will show «GYS-
FLASH 50.24 HF Vx.x»
• Hold the MODE key until the screen displays «lock showroom: Y»
• Charge type:
It is possible to choose the type of charge wanted:
- Automotive charge (automo.) to charge starter batteries.
- Traction charge (traction) to charge traction batteries.
• Cables check:
This mode must be used each time the cables are changed. This charger can be fitted with cables up to 2x8m
in 16mm².
OK : The calibration was successful.
FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory setting.
Check that the cables are in good condition and properly put in short-circuit and repeat the procedure.
• Advanced Menu (code 1-9-6-4) :
This menu is intended for expert user only.
To access this menu, enter in the code («Select» key to change the digit selection and «Start/Stop» key to confirm
the code).
For more details, see next page.
• Reset Memory (code 1-9-6-4) :
This menu is intented to factory reset the charger settings by
entering the code above. Any personal parameters are deleted.
18
GYSFLASH 50.24 HF
in Showroom Mode (To avoid misuse).
RESET MEMORY
RESET MEMORY
Error Code

CONFIGURATION MODE

English
Francais
Deutsch
Nederlands
SETTINGS
Espanol
English
Portugues
Italiano
Russian
...
ON
SETTINGS
restart: ON
OFF
Y (yes)
SETTINGS
lock showroom: N N (no)
automo.
SETTINGS
charge: automo. traction
SETTINGS
Cables Testing: Cables testing
Press START
SETTINGS
Advanced Menu: Advanced menu
Press START
SETTINGS
Reset Memory
Reset Memory:
Press START
0
RESET MEMORY
1
...
Code: 0000
9
Change the
Code NOK code number
Code OK
(1964)
Display 1s
RESET MEMORY
Code OK
Yes
RESET MEMORY
Reset all ?
No
EN
MODE