Cbc Parameters; Calibration - Adam Equipment CBC Serie Manual De Instrucciones

EN
5.0

CBC PARAMETERS

To enter the parameter menus press [Tare] once, during the initial counting of the display after the power is
turned on. The "Weight" display will show
The default password is
four times. Press the [Tare] key.
The Parameter menu has 2 functions that can be accessed using the [U. Wt./Units] key to cycle through the
choices. The "Weight" display will show the name of the functions. To enter a function, press the [Tare]
key. At any time you can press the [Zero] key to return to weighing.
Weight Display
F1 CAL
F2 PIn
6.0

CALIBRATION

The CBC-M approved scales are sealed to prevent unauthorised calibration. Contact Adam Equipment or your
supplier for more details.
The CBC scales are calibrated using metric weights and the CBCa scales can be calibrated using either metric
or pound weights, depending on the unit in use before calibration.
Steps:
1) Press the [Tare] key once, during the initial counting of the display after the power is turned on.The
"Weight" display will show
2) The default password is
[0] key four times and press the [Tare] key.
3) The parameter menu shows
4) The display will then show
[Tare] key to set the zero point.
5) The displays will then show the calibration weight suggested as a whole number. For example:
Either put this weight on the platform after the stable symbol is on or enter the desired value in whole integer
Place the weight on the platform and press [Tare] again.
© Adam Equipment Company 2013
"PIn "
"0000"
but other numbers can be set using the parameter menus. Press the [0] key
Description
See the Calibration section for details.
Set a new password number. Display will show "Pln 1
Enter the new password number then press the [Tare] key.
Display will change to "Pln 2 ", Enter the password again and press [Tare] again.
The display will show "donE" to show the new password has been accepted.
Record the new password number in a secure place.
"PIn "
requesting the password number to be entered.
"0000"
but other numbers can be set using the parameter menus. Press the
"F1 CAL"
. Press [Tare] to enter the Calibration section.
"unLoAd"
"LoAd" "04"
and then press [Tare].
requesting the password number to be entered.
to request all weight be removed from the platform. Press the
"KiLoS"
6 3026610534, Revision A3, July 2013
"