Power Supply - THOMSON RK250 Instrucciones

Power Supply

• Ensure that the voltage is the same as that indicated on the model identification plate.
• Connect the power cable supplied (see battery compartment if necessary) to a properly installed
safety power socket and the mains connector AC on the back of the machine.
Inserting the Batteries (not supplied)
1. Open the lid of the battery compartment.
2. Insert 6 batteries of type UM-2 ("C" size) 1.5 V. Please ensure that the polarity is correct (see the
floor of the battery compartment)!
3. Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are automatically switched off.
CAUTION:
• Batteries can leak and lose battery acid. When not using the system for a long period of time,
remove the batteries.
• Different battery types or new and used batteries must not be used together.
• Do not dispose of batteries with household waste. Return old batteries to the respective collection
facilities or your dealer.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Danger of
explosion!
Setting the clock & date
The system must be in standby mode in order to set the clock.
1. Press and hold the "ENTER / PLAY / PAUSE / CLOCK" button for approx.2 seconds.
2. Use the "SKIP+ / TUNING+" or "SKIP- / TUNING-" buttons to set the time format "12 / 24hr".
3. Press the "ENTER / PLAY / PAUSE / CLOCK" button to confirm time format.
4. Use the "SKIP+ / TUNING+" or "SKIP- / TUNING-" buttons to set the hours accordingly. The hour
digits start flashing.
5. Press the "ENTER / PLAY / PAUSE / CLOCK" button to confirm the hour.
6. Repeat step 4 and 5 to set the minute / date.
NOTE:
• Press and hold the "ENTER / PLAY / PAUSE / CLOCK" button during operation order to briefly
display the current time.
Setting of the alarm time
The system must be in standby mode in order to set the alarm.
You have the option of setting two alarm times. Proceed as follows:
1. Press the "VOLUME- / ALARM 1" button for about 3 seconds. The hours of the currently set alarm
time will start to flash.
2. Perform the settings with the "SKIP+ / TUNING+" or "SKIP- / TUNING-" buttons.
3. Press the "VOLUME- / ALARM 1" button to confirm. The minutes will start to flash.
4. Perform the settings with "SKIP+ / TUNING+" or "SKIP- / TUNING-" buttons.
5. Press the "VOLUME- / ALARM 1" button to confirm. Then choose how you would like to be woken
up. Perform the settings with the "SKIP+ / TUNING+" or "SKIP- / TUNING-" buttons. Press the
"VOLUME- / ALARM 1" to confirm.
- EN 5 -